Valid

GB/T 41270.9-2022Process management for avionics—Atmospheric radiation effects—Part 9: Single event effect fault rate calculation methods and procedures for avionic equipment (English PDF)

航空电子过程管理 大气辐射影响 第9部分:航空电子设备单粒子效应故障率计算程序与方法

Preview PDF

This is a limited preview

Buy now to download the full PDF (24 pages)

Need quotation for your management?

Get a formal quotation for GB/T 41270.9-2022 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

March 9, 2022

Implementation date

October 1, 2022

Scope

GB/T 41270.9-2022 is the English-translated version of 航空电子过程管理 大气辐射影响 第9部分:航空电子设备单粒子效应故障率计算程序与方法.

GB/T 41270.9-2022 is the part of the Chinese series on the atmospheric radiation effects to be managed in avionics that gives the calculation of the single event effect fault rate of an equipment.

It sets the general method of the calculation and then the calculation of the total fault rate, of the soft error rate and of the hard error rate, with the procedure to be followed.

It applies to the development, testing and maintenance of avionics working below 35 km, where cosmic ray secondaries upset memories and logic. Avionics makers, aircraft builders and certification engineers use it. Issued on 9 March 2022, it has applied since 1 October 2022.

Found what you need?

Document preview — GB/T 41270.9-2022

National Standard of the People's Republic of China

ICS
49.020
Classification
V 25

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Preface
  • Introduction
  • 1 Scope
  • 2 Normative references
  • 3 Terms and Definitions
  • 4 Abbreviations
  • 5 Calculation method
  • 5.1 General calculation method
  • 5.2 Calculation method of total failure rate
  • 5.3 Soft failure rate calculation method
  • 5.4 Calculation method of hard failure rate
  • 6 Calculation program
  • 6.1 Calculation flow chart
  • 6.2 Input
  • 6.3 Calculation step
  • 6.4 Output
  • Appendix A (Informative) Calculation Case
  • Appendix B (Informative) List of Sensitive Devices
  • Appendix C (Informative) Calculation Method of Atmospheric Neutron Radiation Stress
  • Appendix D (Informative) Typical Single Event Effect Cross Section Data
  • Reference

Foreword

This document is in accordance with the provisions of GB/T 1.1-2020 "Guidelines for Standardization Work Part 1: Structure and Drafting Rules of Standardization Documents" drafted.

This document is part 9 of GB/T 41270 "Avionics Process Management of Atmospheric Radiation Effects". GB/T 41270 has been released the following parts.

--- Part 7: Process management of single event effects analysis in avionics product design;

--- Part 9: Avionics equipment single event effect failure rate calculation procedures and methods.

Introduction

0.1 Goals This document has been developed for the needs of the analysis and calculation of single event effect failure rates for avionics electronic products.

0.2 Technical overview Avionics equipment working in the atmosphere, its key devices will produce a variety of single-event effects under the radiation of atmospheric neutrons, which are transmitted to the atmosphere.

Avionics, which can produce single event effect soft and/or hard faults, can affect the safety of the aircraft. Considering that only device-level SEE Only the failure rate participates in the safety analysis process at the system level and the aircraft level. Therefore, it is necessary to provide equipment-level information in the process of aircraft safety assessment.

The SEE failure rate and its calculation method and program provide basic data for the safety analysis of avionics equipment.

GB/T 34955-2017 "Guidelines for Single Event Effects Tests of Atmospheric Radiation Affecting Avionics Systems" and GB/T 34956-2017 "Guidelines for the Design of Single Event Effect Protection for Avionics Influenced by Atmospheric Radiation" together constitute the design of single event effects for avionics products Basic technical standards with analysis.

GB/T 41270 specifies methods and procedures for the analysis, testing and evaluation of atmospheric neutron single event effects, and is intended to consist of two parts.

--- Part 7: Process management of single event effects analysis in avionics product design. The purpose is to specify avionics product design Methods and procedures for single event effect analysis of electronic components.

--- Part 9: Avionics equipment single event effect failure rate calculation procedures and methods. The purpose is to specify the avionics list Particle effect failure rate general, total failure rate, soft failure rate, hard failure rate calculation method and calculation program.

0.3 Description of relevant patents The issuing body of this document draws attention to claims that compliance with this document may relate to single event effect failure rates, atmospheric neutron radiation stress, Use of patents related to device sensitive cross-section and derating factor.

The issuing authority of this document has no position on the authenticity, validity and scope of this patent.

The patent holder has undertaken to the issuing body of this document that he is willing to agree with any applicant, on reasonable and non-discriminatory terms and conditions, to Negotiate patent licensing. This patent holder's statement is on file with the issuing agency of this document.

The patentees listed in Table 1 hold the patents covered by this document.

Table 1 Information about the patentee holding the patents involved in this document Patent holder address Beijing Shengtaoping Experimental Engineering Technology Research Institute Co., Ltd. Room 708, China Weapons Building, No. 69 Zizhuyuan Road, Haidian District, Beijing Please note that in addition to the patents mentioned above, some content of this document may still involve patents. The issuing agency of this document does not undertake to identify the patent responsibility.

1 Scope

This document gives the general calculation method of single event effect failure rate of avionics equipment, the calculation method of total failure rate and the calculation method of soft failure rate. method, hard failure rate calculation method and calculation program.

This document applies to the development, testing and maintenance of avionics equipment working in altitudes below 35km.

2 Normative references

The contents of the following documents constitute essential provisions of this document through normative references in the text. Among them, dated citations documents, only the version corresponding to that date applies to this document; for undated references, the latest edition (including all amendments) applies to this document.

GB/T 34955-2017 Guidelines for Single Event Effects Tests of Atmospheric Radiation Affecting Avionics Systems

GB/T 34956-2017 Design guidelines for single event effect protection of avionics equipment affected by atmospheric radiation

3 Terms and Definitions

The terms and definitions defined in GB/T 34956-2017 and the following terms and definitions apply to this document.

3.1 Atmospheric neutron fluence rate

The neutron fluence rate in the atmospheric radiation environment exposed to avionics during a flight mission.

Note: The unit of atmospheric neutron radiation stress is per square centimeter hour [/(cm2·h)].

3.2 Single event effect fault rate

The number of single event effect failures of avionics equipment caused by atmospheric neutron radiation per unit time under the power-on working state.

Note: The unit of single event effect failure rate is times per hour (times/h).

4 Abbreviations

The following abbreviations apply to this document. ADC. analog-to-digital converter AD/DA. analog-to-digital/digital-to-analog conversion (analog-to-digital/digital-to-analogconvert) CCD. charge-coupled device (charge-coupleddevice) DAC. digital-to-analog converter

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 24 pages — is available in the English PDF.

Referenced standards

Similar standards

How to Download GB/T 41270.9-2022

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
24 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 41270.9-2022

$360.00