GB/T 38924.11-2023Environmental test methods for civil small and light unmanned aircraft system—Part 11: Fungus test (English PDF)

Foreword

This document is in accordance with the provisions of GB/T 1.1-2020 "Guidelines for Standardization Work Part 1: Structure and Drafting Rules for Standardization Documents" drafting.

This document is part 11 of GB/T 38924 "Environmental Test Methods for Civilian Light and Small Unmanned Aerial Vehicle Systems". GB/T 38924 has issued Published the following sections.

--- Part 1: General;

--- Part 2: Low temperature test;

--- Part 3: High temperature test;

--- Part 4: Temperature and altitude test;

--- Part 5: Impact test;

--- Part 6: Vibration test;

--- Part 7: Damp heat test;

--- Part 8: Salt spray test;

--- Part 9: Water resistance test;

--- Part 10: Sand dust test;

--- Part 11: Mold test.

Introduction

This document uses live mold spores and provides environmental conditions conducive to mold growth.

GB/T 38924 "Environmental test methods for civil light and small UAV systems" is proposed to be divided into the following parts.

--- Part 1: General. The purpose is to standardize the general requirements for environmental tests of civil light and small UAV systems.

--- Part 2: Low temperature test. The purpose is to standardize the general requirements for low temperature tests of civil light and small UAV systems.

--- Part 3: High temperature test. The purpose is to standardize the general requirements for high temperature tests of civil light and small UAV systems.

--- Part 4: Temperature and altitude test. The purpose is to standardize the general requirements for temperature and altitude tests of civil light and small UAV systems.

--- Part 5: Impact test. The purpose is to standardize the general requirements for the impact test of civilian light and small UAV systems.

--- Part 6: Vibration test. The purpose is to standardize the general requirements for vibration tests of civil light and small UAV systems.

--- Part 7: Damp heat test. The purpose is to standardize the general requirements for the damp heat test of civil light and small unmanned aerial vehicle systems.

--- Part 8: Salt spray test. The purpose is to standardize the general requirements for salt spray tests of civil light and small UAV systems.

--- Part 9: Water resistance test. The purpose is to standardize the general requirements for the water resistance test of civil light and small UAV systems.

--- Part 10: Sand dust test. The purpose is to standardize the general requirements for sand and dust tests of civil light and small UAV systems.

--- Part 11: Mold test. The purpose is to standardize the general requirements for mold testing of civil light and small UAV systems.

1 Scope

This document specifies the mold test for civil light and small unmanned aerial vehicles (take-off mass 0.25kg~150kg) system (including aircraft and ground station): test conditions, test equipment and instruments, test process, test interruption and recovery, test result evaluation and test report.

This document is applicable to civil light and small unmanned aerial vehicle systems that will be affected by the mold environment during transportation, storage, and use.

2 Normative references

The contents of the following documents constitute the essential provisions of this document through normative references in the text. Among them, dated references For documents, only the version corresponding to the date applies to this document; for undated reference documents, the latest version (including all amendments) applies to this document.

GB/T 38924.1-2020 Environmental test methods for civil light and small unmanned aerial vehicle systems Part 1: General

HB 6167.11-2014 Environmental conditions and test methods for airborne equipment of civil aircraft Part 11: Mold test

3 Terms and Definitions

The following terms and definitions apply to this document.

4 Test conditions