Valid

GB/T 37630-2019Textiles—Quantitative chemical analysis—Mixtures of acetate or triacetate with certain other fibres (method using hydrochloric acid) (English PDF)

纺织品 定量化学分析 醋酯纤维或三醋酯纤维与某些其他纤维的混合物(盐酸法)

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 37630-2019 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

June 4, 2019

Implementation date

January 1, 2020

Scope

GB/T 37630-2019 is the English-translated version of 纺织品 定量化学分析 醋酯纤维或三醋酯纤维与某些其他纤维的混合物(盐酸法).

GB/T 37630-2019 is the Chinese standard "Textiles - Quantitative chemical analysis - Mixtures of acetate or triacetate with certain other fibres (method using hydrochloric acid)".

Its scope clause reads: This Standard specifies the method for determining the fiber content in the mixture of acetate or triacetate and certain other fibers after removing the non-fibrous materials by the hydrochloric acid method.

This Standard is applicable to the binary mixture of acetate fiber with wool, cashmere, other animal fibers, silk, cotton, ramie, linen, viscose fiber, modal fiber, lyocell fiber, polyacrylonitrile fiber, polyester fiber, spandex and polylactic-acid fiber; as well as the binary mixture of triacetate fiber with polyacrylonitrile fiber, polyester fiber, and polylactic-acid fiber.

Other similar fibers can refer to this Standard. Its clauses include principle; reagents; equipment; test procedures; calculation and expression of results; precision; test report.

It was issued by the State Administration for Market Regulation on JUNE 04, 2019 and took effect on JANUARY 01, 2020.

Found what you need?

Document preview — GB/T 37630-2019

National Standard of the People's Republic of China

ICS
59.080.01
Classification
W 04

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Foreword3
  • 1 Scope4
  • 2 Normative References4
  • 3 Principle4
  • 4 Reagents5
  • 5 Equipment5
  • 6 Test Procedures5
  • 7 Calculation and Expression of Results6
  • 8 Precision6
  • 9 Test Report7

1 Scope

This Standard specifies the method for determining the fiber content in the mixture of acetate or triacetate and certain other fibers after removing the non-fibrous materials by the hydrochloric acid method.

This Standard is applicable to the binary mixture of acetate fiber with wool, cashmere, other animal fibers, silk, cotton, ramie, linen, viscose fiber, modal fiber, lyocell fiber, polyacrylonitrile fiber, polyester fiber, spandex and polylactic-acid fiber; as well as the binary mixture of triacetate fiber with polyacrylonitrile fiber, polyester fiber, and polylactic-acid fiber. Other similar fibers can refer to this Standard.

2 Normative References

The following documents are essential to the application of this document. For the dated documents, only the versions with the dates indicated are applicable to this document; for the undated documents, only the latest version (including all the amendments) are applicable to this document.

GB/T 2910.1 Textiles - Quantitative Chemical Analysis - Part 1: General Principles of Testing

3 Principle

Use hydrochloric acid to dissolve and remove the acetate or triacetate fibers from the mixture with known dry mass; collect the residue; clean, dry and weigh; calculate the percentage of the corrected mass accounting for the dry mass of the mixture. Then calculate the mass percentage of acetate or triacetate fibers from the difference. neutralize for twice; then use clean water to wash. Firstly, conduct the gravity drainage, then conduct the pumping drainage for each washing; finally, dry, cool-off, weigh the crucible and the residue.

6 Test Procedures

6.2 Mixture of triacetate fibers with certain other fibers

Pipette hydrochloric acid solution (4.1); its consumption shall be calculated by adding 100mL of solution (4.1) per gram of specimen. Then add it into the conical flask; pre-heat to (60±2) °C; then place the specimen into the conical flask; cover the stopper; shake the conical flask to make it fully wet; then oscillate on the (60±2) °C constant temperature water bath oscillator (5.2) for 70min. Use the glass sand core with known mass to filter; wash the remaining fibers with a small amount of hydrochloric acid solution (4.1) at the same temperature for 3 times. Then use clean water to wash for 4~5 times; then use of dilute ammonia solution (4.2) to neutralize for twice. Firstly, conduct the gravity drainage, then conduct the pumping drainage for each washing; finally, dry, cool-off, weigh the crucible and the residue.

NOTE: In case some dark samples are not completely dissolved, the reagent can be replaced once during the dissolving process; and appropriately extend the dissolution time.

7 Calculation and Expression of Results

The calculation and expression of results shall be as specified in GB/T 2910.1.

The value-d for mixture of acetate fiber and other fibers, cotton, ramie, viscose fiber, lyocell fiber, modal fiber, cashmere is 1.01; the Value-d for linen is 1.04; the Value-d for silk, spandex is 1.02; and the Value-d for other fibers is 1.00.

The Value-d for mixture of triacetate fiber and other fibers, polyacrylonitrile fiber, polyester fiber, polylactic-acid fiber is 1.00.

If the error of the measures results of two specimens is greater than 1%, take the third specimen; the measured results shall be expressed by the average of the three measured results.

8 Precision

For the homogeneous textile material mixture, the confidence limit for this Standard test results does not exceed ±2% at a 95% confidence level. […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Referenced standards

Similar standards

How to Download GB/T 37630-2019

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 37630-2019

$75.00