GB/T 36032-2018Press tools for tablets -- Punches and dies (English PDF)

Foreword

This standard was drafted in accordance with the rules given in GB/T 1.1-2009.

This standard uses the translation method equivalent to the use of ISO 18084.2011 "Pressure die punch and die."

The Chinese documents that have a consistent correspondence with the normatively cited international documents in this standard are as follows.

---GB/T 1804-2000 Tolerances for tolerances in linear and angular dimensions for general tolerances (eqvISO 2768-1.1989)

1 Scope

This standard specifies the dimensions, tolerances, and characteristics of punches and dies in various shapes.

This standard deals with the metric method of die interchange in tablet presses of different manufacturers.

2 Normative references

The following documents are indispensable for the application of this document. For dated references, only dated versions apply to this article

Pieces. For undated references, the latest version (including all amendments) applies to this document.

ISO 2768-1 General tolerances - Part 1. Tolerances for linear and angular dimensions without tolerances (General tolerances - Part

1 Tolerancesforlinearandangulardimensionswithoutindividualtoleranceindications)

3 Private name

See Figure 1 and Figure 2.