GB/T 35866-2018Inspection of grain and oils-Determination of solvent retention capacity of wheat flour (English PDF)
粮油检验 小麦粉溶剂保持力的测定
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 35866-2018 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
February 6, 2018
Implementation date
September 1, 2018
Scope
GB/T 35866-2018 is the English-translated version of 粮油检验 小麦粉溶剂保持力的测定.
GB/T 35866-2018 is the Chinese national method for measuring the solvent retention capacity (SRC) of wheat flour, that is, the amount of solvent the flour holds after centrifugation, expressed as a percentage on a 14% moisture basis.
The flour is mixed and swollen with four solvents - deionized water, 50% sucrose solution, 5% sodium carbonate solution and 5% lactic acid solution - then centrifuged.
Each result reflects a different property: overall flour components, pentosan and gliadin, the degree of damage to the flour particles and gluten characteristics.
The standard gives two procedures, a constant method for the general determination and a micro method intended for early-generation wheat breeding, with the reagents, equipment, analysis steps, calculation, precision and test report for each. It was issued on 6 February 2018 and has applied since 1 September 2018.
Found what you need?
Document preview — GB/T 35866-2018
National Standard of the People's Republic of China
- ICS
- 67.060
- Classification
- X 11
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Foreword
- 1 Scope
- 2 Normative references
- 3 Terms and definitions
- 4 Constant method
Foreword
This standard was drafted in accordance with the rules given in GB/T 1.1-2009.
1 Scope
This standard specifies the principle of wheat powder solvent retention constant determination and trace determination, reagents and solutions, equipment, analysis steps, knot Fruit calculation, precision and test report.
The first method of this standard applies to the determination of wheat flour solvent retention; the second method is suitable for the early breeding of wheat flour in the solvent retention Determination.
2 Normative references
The following documents for the application of this document is essential. For dated references, only the dated version applies to this document. For undated references, the latest edition (including all amendments) applies to this document.
GB 5009.3 National Food Safety Standard Determination of moisture in food
GB/T 6682 analytical laboratory water specifications and test methods
NY/T 1094.2 Wheat Experimental Milling - Part 2. Bühler Method for Hard Wheat
NY/T 1094.4 Wheat Experimental Milling - Part 4. Buhler's Method for Soft Wheat Extract
NY/T 1094.5 Wheat Experimental Flour Part 5. Brabender Quadruple Jr. (Quadruplex) Experimental Mill Method
3 Terms and definitions
The following terms and definitions apply to this document.
3.1 Solvent retention capacity; SRC
Wheat flour in a certain amount of centrifugal force can maintain the amount of solvent. Expressed as a percentage (%).
Note: expressed as a percentage of the solvent retained by wheat flour with a moisture content of 14% (mass fraction).
4 Constant method
4.1 Principle
Wheat flour, respectively, and deionized water, 50% (mass fraction) sucrose solution, 5% (mass fraction) sodium carbonate solution and 5% (mass fraction) lactic acid solution after mixing fully swollen, centrifuged, measuring the amount of wheat flour to maintain the solvent. Water solvent retention can reflect all components of wheat flour Properties; sucrose solvent retention can reflect the pentose content of wheat flour and gliadin properties; sodium carbonate solvent retention can reflect the wheat flour The degree of damage of the particles; lactic acid solvent retention can reflect the gluten characteristics of wheat flour.
4.2 Reagents and solutions
4.2.1 Unless otherwise specified, only the reagents identified as analytically pure and the isolates that meet the Grade III water requirements of GB/T 6682 are used in the analysis Water.
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Normative references
- GB 5009.3National food safety standard - Determination of Moisture Content in Foods
- GB/T 6682Water for analytical laboratory use - Specification and test methods
- NY/T 1094.2Wheat experimental milling. Part 2: Buehler method for hard wheat
- NY/T 1094.4Wheat experimental milling. Part 4: Buehler method for soft wheat straight-grade flour
- NY/T 1094.5Wheat experimental milling. Part 5: Brabender Quadrumat Jr. (Quadruples) method
Similar standards
How to Download GB/T 35866-2018
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB 5009.3-2010 — National food safety standard - Determination of moisture in foods
GB 5009.3-2016 — National food safety standard - Determination of Moisture Content in Foods
GB/T 6682-1992 — Water for analytical laboratory use--Specification and test methods
GB/T 35866-2018
$145.00