Valid

GB/T 33916-2017Animal and vegetable fats and oils -- Determination of conventional mass per volume (liter weight in air) (English PDF)

动植物油脂 常规单位体积质量(每升在空气中的重量)的测定

Preview PDF

This is a limited preview

Buy now to download the full PDF (17 pages)

Need quotation for your management?

Get a formal quotation for GB/T 33916-2017 in 30 minutes.

Issued by

General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China, Standardization Administration of the People's Republic of China

Level / Type

National · Recommended

Issue date

July 12, 2017

Implementation date

February 1, 2018

Scope

GB/T 33916-2017 is the English-translated version of 动植物油脂 常规单位体积质量(每升在空气中的重量)的测定.

GB/T 33916-2017 — This standard specifies the determination of animal and plant fats and oils (hereinafter referred to as grease) conventional unit volume mass (per liter in air weight) For volume and quality conversion between each other.

This standard applies to liquid state grease. In the determination of the temperature should ensure that the oil does not appear crystallized.

Found what you need?

Document preview — GB/T 33916-2017

National Standard of the People's Republic of China

ICS
67.200.10
Classification
X 14

Issued by: General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China, Standardization Administration of the People's Republic of China

Contents

  • Foreword
  • 1 Scope
  • 2 Normative references
  • 3 Terms and definitions
  • 4 principle
  • 5 instruments
  • 5.1 water bath. Can control the temperature, the change in the range of +/- 0.1 degrees C.
  • 5.2 Densitometer (Jaulmes) A capacity of 50 mL with lateral neck.

Foreword

This standard was drafted in accordance with the rules given in GB/T 1.1-2009.

This standard is equivalent to the international standard ISO 6883.2007 "Animal and vegetable fats and oils conventional unit volume mass (per liter of air in the weight

Amount) of the determination. "

The documents of our country that are consistent with the corresponding international documents that are normative references in this standard are as follows.

--- GB/T 15687-2008 Animal and vegetable fats sample preparation (ISO 661.2003, IDT);

Laboratory glassware densitometer (ISO 3507.1999, IDT) - GB/T 21785-2008.

This standard proposed by the State Food Administration.

This standard by the National Cereals and Oils Standardization Technical Committee (SAC/TC270) centralized.

This standard was drafted by the State Food Administration of Science.

1 Scope

This standard specifies the determination of animal and plant fats and oils (hereinafter referred to as grease) conventional unit volume mass (per liter in air weight)

For volume and quality conversion between each other.

This standard applies to liquid state grease.

In the determination of the temperature should ensure that the oil does not appear crystallized.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version applies to this document. For undated references, the latest edition (including all amendments) applies to this document.

ISO 661 Animal and vegetable fats sample preparation (Animalandvegetablefatsandoils-Preparationoftestsam-

ple

ISO 3507 laboratory glass densitometer (Laboratoryglassware-Pyknometers)

3 Terms and definitions

The following terms and definitions apply to this document.

3.1

Conventional unit volumetric massmassmasspervolume

Literweightinair per liter of weight in the air

The ratio of mass to volume of grease in air at the stated temperature.

Note. The conventional unit volume mass is expressed in kilograms per liter (numerically equivalent to grams per milliliter).

4 principle

Measure the mass of the measured liquid grease in the calibrated densitometer at the specified temperature.

5 instruments

Laboratory equipment commonly used, especially the following equipment.

5.1 water bath. Can control the temperature, the change in the range of +/- 0.1 degrees C.

Water bath with a calibrated fixed thermometer, thermometer scale accuracy of 0.1 degrees C, thermometer range should be applied to the temperature

range.

5.2 Densitometer (Jaulmes) A capacity of 50 mL with lateral neck.

Density meter Cone can be fixed at a calibrated and graduated 0.1 ° C thermometer with a perforated lid on the top of the neck or

Plug (see Figure 1).

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 17 pages — is available in the English PDF.

Referenced standards

Normative references

ISO 661 · ISO 3507

How to Download GB/T 33916-2017

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
17 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 33916-2017

$145.00