GB/T 32800.10-2023Hand-held non-electric power tools - Safety requirements - Part 10: Compression power tools (English PDF)

1 Scope

This document applies to hand-held non-electric power supplies for extrusion riveting, stamping, forming, and pressure cutting of metals, plastics, and other materials.

Tools (hereinafter referred to as "squeeze power tools"). Extrusion power tools can be powered by compressed air, hydraulic oil or an internal combustion engine, with or without

In the case of a suspension device (such as a balance device), it is intended for use by an operator with one or two hands.

Note 1.At the time of publication of this document, the existence of extrusion power tools driven by internal combustion engines has not been known. This document will be updated once the existence of such power tools is confirmed.

Amended to include it.

This document applies to the following products.

--- Withholding tools;

--- Ring part breaker;

--- Tools for metal forming (edge formers, folding tools, fasteners);

--- Nut splitter;

--- extruder;

---printer;

--- Extrusion riveter;

--- Cutting tools with parallel blades;

--- Jaw squeeze pliers.

Note 2.See Appendix B for examples of extrusion power tools.

This document does not apply to special requirements and modifications to extrusion-type power tools for mounting them on holding devices.

This document deals with reasonably foreseeable errors in intended use and at the factory, other than the use of extruded power tools in potentially explosive atmospheres.

All noteworthy hazards, hazardous conditions or hazardous occurrences when using the tool under the conditions of use.

Note 3.EN13463-1 gives the requirements for the use of non-electrical equipment in potentially explosive atmospheres.

2 Normative references

The contents of the following documents constitute the essential provisions of this document through normative references in the text. Among them, dated references

For documents, only the version corresponding to the date is applicable to this document; for undated reference documents, the latest version (including all amendments) is applicable to this document.

GB/T 15706-2012 Risk Assessment and Risk Reduction of Machinery Safety Design General Principles (ISO 12100.2010, IDT)

ISO 3857-3 Vocabulary for compressors, air tools and machinery Part 3.Pneumatic tools and machinery (Compressors,

Note. GB/T 6247.4-2013 Terminology for rock drilling machinery and portable power tools Part 4.Performance test (ISO 3857-3.1989, MOD)

Note. GB/T 6247.1-2013 Terminology for rock drilling machinery and portable power tools Part 1.Rock drilling machinery, pneumatic tools and pneumatic machinery (ISO 5391.2003, MOD)

ISO 13732-1 Ergonomics of thermal environments - Methods for the evaluation of the human body's response to touching surfaces - Part 1.Hot surfaces (Ergo-

GB/T 45677 | GB/T 5357 | JB/T 3943 | GB/T 32800.5 | GB/T 32800.2 | GB/T 32800.1 | […]