GB/T 29598-2013Limit and determination of triazines in fluorescent brighteners (English PDF)
荧光增白剂中三嗪类杂质的限量与测定
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 29598-2013 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
July 19, 2013
Implementation date
December 1, 2013
Scope
GB/T 29598-2013 is the English-translated version of 荧光增白剂中三嗪类杂质的限量与测定.
GB/T 29598-2013 fixes the limits for triazine impurities in fluorescent brighteners used in detergents and the method of determining them, the impurities concerned being listed in Appendix A of the standard.
Clause 1 states that the standard applies to fluorescent brighteners for detergents, and the standard opens with a warning that it is to be used by personnel with regular laboratory experience, that it does not identify every possible safety problem, and that users are responsible for adopting appropriate safety and health practices and for complying with the relevant national regulations.
Clause 3 carries the requirements: Table 1 sets the limits of the three impurities as percentages, with triazine 1 (AAH) and triazine 2 (AMM) each limited to not more than 0.10 per cent and triazine 3 (AAM) to not more than 0.50 per cent, and refers the test for each of them to clause 4.
Clause 4 is the test method, with 4.1 on general provisions requiring analytical reagents and water of the grade specified in GB/T 6682-2008 and judgement of results by the rounded value comparison method of 4.3.3 of GB/T 8170-2008; 4.2 gives the principle, in which the brightener sample is dissolved in the mobile phase, separated by high performance liquid chromatography, measured at the wavelength of maximum absorption and quantified from the peak areas by the external standard method; and 4.3 lists the reagents and solutions, beginning with acetonitrile.
The normative references are GB/T 6682-2008 on water for analytical laboratory use and GB/T 8170-2008. The standard was drafted following the rules of GB/T 1.1-2009, was proposed by the China Petroleum and Chemical Industry Association and is administered by the national technical committee on dyes, SAC/TC 134.
It is classified under ICS 71.100.01 and 87.060.10 and Chinese classification G55. It was issued on 2013-07-19 and has applied since 2013-12-01.
Found what you need?
Document preview — GB/T 29598-2013
National Standard of the People's Republic of China
- ICS
- 71.100.01; 87.060.10
- Classification
- G 55
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Foreword
- 1 Scope
- 2 Normative references
- 3 Requirements
- 4 Test Method
Foreword
This standard was drafted in accordance with GB/T 1.1-2009 given rules. The standard proposed by China Petroleum and Chemical Industry Association.
1 Scope
This standard specifies the standard detergent with fluorescent brighteners, and determination of the triazine impurities (see Appendix A) limit.
This standard applies to detergents with optical brighteners.
2 Normative references
The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein Member. For undated references, the latest edition (including any amendments) applies to this document.
GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)
GB/T 8170-2008 revised value represents about rules and limit values and judgment
3 Requirements
Detergent with fluorescent brighteners quality triazine impurity shall comply with the requirements of Table 1.
4 Test Method
4.1 General provisions
Unless otherwise specified, use only recognized as analytical reagents and GB/T 6682-2008 specified level of water. Test results judgment Given in GB/T 8170-2008 4.3.3 Rounding the value comparison method.
4.2 Principle
Fluorescent Brightener sample after dissolving the mobile phase, high performance liquid chromatography detach it, the response was measured at the maximum absorption wavelength We should value, peak area using external standard quantitative determination of the content of which three triazine impurities.
4.3 Reagents and solutions
4.3.1 Acetonitrile.
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Similar standards
How to Download GB/T 29598-2013
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 6682-2008 — Water for analytical laboratory use - Specification and test methods
GB/T 8170-2008 — Rules of rounding off for numerical values & expression and judgement of limiting values
GB/T 10003-2026 — Biaxially oriented polypropylene (BOPP) film
GB/T 29598-2013
$125.00