GB/T 29132-2018Ships and marine technology -- Marine environment protection -- Adapter for joining dissimilar boom connectors (English PDF)

Foreword

This standard was drafted in accordance with the rules given in GB/T 1.1-2009.

This standard replaces the connection between GB/T 29132-2012 "ship and marine technology marine environmental protection different boom joints" adapter". Compared with GB/T 29132-2012, the main technical changes of this standard are as follows.

--- Removed Chapter 2 normative references (see Chapter 2 of the 2012 edition);

--- Revised the definition of the boom and tensile strength (see 2.1, 2.6, 3.1, 3.6 of the 2012 edition);

--- Revised the security requirements in the general functional requirements (see Chapter 3, 4.8 of the 2012 edition);

--- Increased bolt size values in inches (see 4.2, Figure 2);

---Modified the value of the hole distance deviation between the bolt hole and the water line [see Figure 1, Figure 1a of the 2012 edition)];

--- Removed the size of the bolt hole in the example of the boom adapter connection [Fig. 1a of the 2012 edition]];

--- Added the requirement that the bolts can be used with the same properties as AISI316 stainless steel (see Figure 2);

--- Removed the material requirements for the lock nut [see Figure 1b of the 2012 edition), 5.5];

--- Removed the manufacturer's requirements for the tensile strength performance test of the boom (see 5.8 of the 2012 edition);

--- Remove the leak prevention requirements for holes designed directly on the boom connector that do not apply to the adapter (see 5.9 of 2012 edition);

--- Increased the requirement for tensile stress transfer between booms when connecting adapters (see 4.7);

--- Increased the requirement that the boom equipment should not reduce the operational performance of the connected boom (see 5.4).

This standard uses the translation method equivalent to ISO 16446:2013 "ship and marine technology marine environmental protection different boom joints Between the connection adapters.

1 Scope

This standard specifies a general method of using standard adapters to connect to booms with different types of joints.

This standard does not address all safety precautions (if any) related to use. Users of this standard are responsible for making appropriate Safety and health practices, and clarify the scope of application of relevant regulations.

2 Terms and definitions

The following terms and definitions apply to this document.

3 General functional requirements

Any boom connector shall be designed to meet the following requirements to ensure successful use of the adapter to connect different types of boom connectors.

--- The boom connector shall be of sufficient strength to withstand the corresponding pulling force of the type, size and purpose of the connected boom.

--- Oil leakage between the boom section and the section should be avoided.

--- Whether in water, water, or in water containing oil, dirt or ice, or large waves, the boom connector should be strong and Easy to connect and disassemble. For those joints that need to be embedded in each other, it is advisable to simply pull the ends together