Valid

GB/T 27973-2011Methods for chemical analysis of volatilized silica (English PDF)

硅灰的化学分析方法

Preview PDF

This is a limited preview

Buy now to download the full PDF (18 pages)

Need quotation for your management?

Get a formal quotation for GB/T 27973-2011 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

December 30, 2011

Implementation date

October 1, 2012

Scope

GB/T 27973-2011 is the English-translated version of 硅灰的化学分析方法.

GB/T 27973-2011 is the Chinese standard "Methods for chemical analysis of volatilized silica". Its scope clause reads: This standard specifies the silica fume silica, iron oxide, magnesium oxide, loss on ignition, alkali content, water content and analysis of chloride ion.

This standard applies to cohesion and silica fume silica fume. Its clauses include reagents and materials.

Found what you need?

Document preview — GB/T 27973-2011

National Standard of the People's Republic of China

ICS
91.100.10
Classification
Q 11

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • 1 Scope1
  • 2 Normative references1
  • 4 Reagents and materials1
  • 5 instruments and equipment8
  • 7 Determination of moisture content of10
  • 8 - Determination of loss on ignition ignition subtraction ---10
  • 9 Determination of chloride --- ammonium thiocyanate volumetric method (Reference method)11
  • 11 Determination of potassium oxide and sodium oxide --- a flame photometric method (Reference method)12
  • 12 Determination of potassium oxide and sodium oxide --- Atomic Absorption Spectrometry (generation of usage)13
  • 13 Determination of silicon dioxide --- ammonium chloride gravimetric method (Reference method)14
  • 14 Determination of silicon dioxide --- potassium fluosilicate volumetric method (generation of usage)15
  • 15 Determination of ferric oxide --- Phenanthroline spectrophotometric method (Reference method)16
  • 16 Determination of ferric oxide --- EDTA direct titration (on behalf of usage)17
  • 17 Determination of magnesium by atomic absorption spectrometry ---17
  • 18 repeatability limit and reproducibility limit18

1 Scope

This standard specifies the silica fume silica, iron oxide, magnesium oxide, loss on ignition, alkali content, water content and analysis of chloride ion.

This standard applies to cohesion and silica fume silica fume.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein

Member. For undated references, the latest edition (including any amendments) applies to this document.

GB/T 2007.1 bulk minerals sampling and sample preparation General manual sampling methods

Laboratory use specifications and test methods GB/T 6682 Analysis

Glass Container JJG196 common test procedures

Basic requirements 3 trials

3.1 represents the quality, volume and results

Mass in grams, accurate to 0.0001g. Unless otherwise specified, the volume of straw represented by mL accuracy by JJG196 Regulation

Scheduled execution.

The test results in mass fraction, calculated chlorine test results and expressed to three decimal places, other ingredients are expressed to one decimal

Two.

3.2 blank test

The same amount of reagents, no test, tested in accordance with the same measurement step, the measurement result is corrected.

3.3 Burning

The filter paper and precipitate into previously been burned and constant crucible and drying. In an oxidizing atmosphere ashing slowly, so that the flame does not produce

Health, ashing to no black carbon particles, into the high-temperature furnace (5.5), and at a predetermined temperature burning. Cool to room temperature in a desiccator, and weigh.

3.4 constant

After the first burning, cooling, weighing, by continuous burning for every 15min, then cooled, weighing method to check the constant quality

Amount, when the difference is less than two consecutive weighing 0.0005g, which reached constant.

4 Reagents and materials

4.1 General

The reagent is not less than analytical. For calibration and reagent preparation of standard solutions, unless otherwise stated should be the base reagent. The water

Shall comply with the requirements of the three water GB/T 6682 stipulated.

END: Draft Version (GB/T 27973-2011)

GB/T 31289-2025 | GB/T 21371-2019 | GB 31893-2015 | GB/T 27977-2022 | GB/T 27975-2011 | GB/T 27974-2011 |

Quality Assurance | How to buy PDFs? | FAQ Terms of Service | Contact Information | Privacy Policy | Refund Policy | Shipping Policy […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 18 pages — is available in the English PDF.

Similar standards

How to Download GB/T 27973-2011

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
18 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 27973-2011

$315.00