Valid

GB/T 23835.8-2009Lithium perchlorate anhydrous - Part 8: Determination of potassium and sodium content (English PDF)

无水高氯酸锂 第8部分:钾和钠含量的测定

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 23835.8-2009 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

May 18, 2009

Implementation date

February 1, 2010

Scope

GB/T 23835.8-2009 is the English-translated version of 无水高氯酸锂 第8部分:钾和钠含量的测定.

GB/T 23835.8-2009 is the Chinese standard "Lithium perchlorate anhydrous - Part 8: Determination of potassium and sodium content".

Its scope clause reads: This section provides a summary of the method of determination of lithium perchlorate anhydrous potassium and sodium content, safety tips, general provisions, reagents, instrument Device, equipment, analytical procedures and the results of calculations.

This section applies to the determination of lithium perchlorate anhydrous potassium and sodium content, linear range. 0.006µg/mL ~ 0.4µg/mL (K), 0.008µg/mL ~ 1.5µg/mL (sodium). Its clauses include method summary; safety tips; general provisions; reagents.

Found what you need?

Document preview — GB/T 23835.8-2009

National Standard of the People's Republic of China

ICS
71.060.01
Classification
G 10

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • 1 Scope
  • 2 Normative references
  • 3 Method summary
  • 4 Safety Tips
  • 5 General Provisions
  • 6 Reagents

1 Scope

This section provides a summary of the method of determination of lithium perchlorate anhydrous potassium and sodium content, safety tips, general provisions, reagents, instrument

Device, equipment, analytical procedures and the results of calculations.

This section applies to the determination of lithium perchlorate anhydrous potassium and sodium content, linear range. 0.006µg/mL ~ 0.4µg/mL (K),

0.008µg/mL ~ 1.5µg/mL (sodium).

2 Normative references

The following documents contain provisions which, through reference GB/T 23835 in this section constitute provisions of this section. For dated reference documents

Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section

Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)

Preparation of HG/T 3696.2 inorganic chemical products, chemical analysis of impurity standard solution

Preparations of HG/T 3696.3 inorganic chemical products, chemical analysis

3 Method summary

The sample is dissolved in water by atomic absorption spectroscopy at a wavelength of 766.5nm (K) and 589.0nm (sodium) at the air - acetylene flame, using

Standard addition method were measured.

4 Safety Tips

Reagents used in this test method has a poisonous and corrosive, the operator must be careful! Should immediately splashed on the skin, such as

Rinse water, severe cases should be treated immediately.

5 General Provisions

This part of the reagents and water in the absence of other requirements specified, refers to two analytical reagent and GB/T 6682-2008 specified in water. Impurities used in the test standard solution, preparations and products, did not indicate when the other requirements, according to HG/T 3696.2,

HG/T 3696.3 regulations of preparation.

6 Reagents

6.1 the nitric acid solution

1 + 4;

6.2 Standard Potassium solution

1mL solution containing potassium (K) 0.010mg;

Pipette Pipette 1.00mL potassium standard solution according to HG/T 3696.2 prepared, placed in 100mL volumetric flask, dilute with water to

Mark and shake. The solution is using now.

6.3 Sodium standard solution

1mL solution containing sodium (Na) 0.010mg;

Pipette Pipette 1.00mL sodium standard solution according to HG/T 3696.2 prepared, placed in 100mL volumetric flask, dilute with water to

Mark and shake. The solution is using now.

GB/T 23940-2021 | GB/T 23769-2009 | GB/T 23774-2009 | GB/T 23835.12-2009 | GB/T 23835.1-2009 | GB/T 23835.11-2009 | […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Similar standards

How to Download GB/T 23835.8-2009

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 23835.8-2009

$105.00