GB/T 23834.5-2009Chemical analysis method for stannous sulfate - Part 5: Determination of arsenic content - Silver diethyldithiocarbamate spectrophotometry (English PDF)
硫酸亚锡化学分析方法 第5部分:砷含量的测定 二乙基二硫代氨基甲酸银分光光度法
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 23834.5-2009 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
May 18, 2009
Implementation date
February 1, 2010
Scope
GB/T 23834.5-2009 is the English-translated version of 硫酸亚锡化学分析方法 第5部分:砷含量的测定 二乙基二硫代氨基甲酸银分光光度法.
GB/T 23834.5-2009 is the Chinese standard "Chemical analysis method for stannous sulfate - Part 5: Determination of arsenic content - Silver diethyldithiocarbamate spectrophotometry".
Its scope clause reads: This section defines the principle of the method diethyl dithiocarbamate spectrophotometric determination of silver and tin sulfate arsenic content, safety tips, General rule, the analysis step, the results of calculations.
This section applies to the determination of arsenic content stannous sulfate. Measurement range. 0.001% to 0.050%. Its clauses include principle of the method; safety tips; general provisions; reagents and materials.
Found what you need?
Document preview — GB/T 23834.5-2009
National Standard of the People's Republic of China
- ICS
- 71.060.01
- Classification
- G 10
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- 1 Scope
- 2 Normative references
- 3 PRINCIPLE OF THE METHOD
- 4 Safety Tips
- 5 General Provisions
- 6 Reagents and materials
1 Scope
This section defines the principle of the method diethyl dithiocarbamate spectrophotometric determination of silver and tin sulfate arsenic content, safety tips,
General rule, the analysis step, the results of calculations.
This section applies to the determination of arsenic content stannous sulfate. Measurement range. 0.001% to 0.050%.
2 Normative references
The following documents contain provisions which, through reference GB/T 23834 in this section constitute provisions of this section. For dated reference documents
Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section
Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.
Preparation of standard solution of GB/T 602 chemical reagent determination of impurities (GB/T 602-2002, ISO 6353-1. 1982, NEQ)
GB/T 603 chemical reagent test methods in the formulation and preparation of products (GB/T 603-2002, ISO 6353-1 with. 1982,
NEQ)
GB/T 6682-2008 analytical laboratory use specifications and test methods (ISO 3696. 1987, MOD)
Preparation of HG/T 3696.2 inorganic chemical products, chemical analysis of impurity standard solution
Preparations of HG/T 3696.3 inorganic chemical products, chemical analysis
3 PRINCIPLE OF THE METHOD
In acidic medium, with stannous chloride reduction of arsenic, while new eco-hydrogen reaction of zinc with hydrochloric acid and the formation of hydrogen arsenide, lead
Into diethyl dithiocarbamate silver [Ag (DDTC)] absorbent solution to form a yellow or red brown silver sol, the color depth and containing arsenic
Proportional to the amount, in line with Lambert - Beer law, the absorbance was measured with a spectrophotometer to obtain the arsenic content in tin sulfate through the curve.
4 Safety Tips
Reagents used in this test method are toxic or corrosive, be careful when operating! As splashed on the skin or eyes should stand
That is rinsed with water, severe cases should be treated immediately.
5 General Provisions
This standard reagents and water, did not indicate when the other requirements, refer to analytically pure reagents and GB/T 6682-2008 stipulated three
Grade water. Impurities used in the test standard solution, preparations and products, did not indicate when the other requirements, according to GB/T 602, GB/T 603 or
HG/T 3696.2, the provisions of HG/T 3696.3 of preparation.
6 Reagents and materials
6.1 arsenic-free zinc particles
particle size 3.0mm ± 0.2mm;
GB/T 23940-2021 | GB/T 23769-2009 | GB/T 23774-2009 | GB/T 23834.7-2026 | GB/T 23834.4-2009 | GB/T 23834.3-2009 | […]
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Similar standards
How to Download GB/T 23834.5-2009
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 23834.6-2009 — Chemical analysis method for stannous sulfate - Part 6: Determination of iron content - 1,10-phenanthroline spectrophotometry
GB/T 23834.4-2009 — Chemical analysis method for stannous sulfate - Part 4: Determination of lead and copper content - Flame atomic absorption spectrometry
GB/T 23834.7-2026 — Chemical analysis methods for stannous sulfate - Part 7: Determination of copper, lead, arsenic, iron, antimony, potassium, sodium, calcium and magnesium contents - Inductively coupled plasma optical emission spectrometry
GB/T 23834.5-2009
$105.00