GB/T 21862.3-2008Paints and varnishes -- Determination of density -- Part 3: Oscillation method (English PDF)

Foreword

GB/T 21862 "Paints and varnishes - Determination of density" includes the following four parts.

--- Part 2. Falling Ball Method;

--- Part 3. vibration method;

--- Part 4. Pressure cup method;

--- Part 5. hydrometer method.

This is Part 3 GB/T 21862 of.

This section is equivalent to using the ISO 2811-3:1997 "Paints and varnishes - Determination of density - Part 3. Vibration Law" (in English).

This part of ISO 2811-3:1997 compared to do the following editorial changes.

--- With "this Part" instead of "ISO 2811 part of this";

--- Use has been tantamount to the adoption of national standards instead of into the corresponding international standards or foreign standards;

"." --- With a decimal point instead of a comma as the decimal point, "";

--- Delete international standards foreword.

GB/T 21862 "Paints and varnishes - Determination of density," the relevant standards. GB/T 6750-2007 test "Paints and varnishes density Given pycnometer method "(ISO 2811-1:1997, IDT).

Appendix A of this section is normative appendix, Appendix B and Appendix C are informative appendices.

This part of the National Chemicals Management Standardization Technical Committee dangerous (SAC/TC251) and focal points.

This section is responsible for drafting. Jiangsu Entry-Exit Inspection and Quarantine Bureau.

Participated in the drafting of this section. the Chemical Institute of Standardization, Marine Chemicals Research Institute, China National Chemical Construction Corporation of Changzhou coating Power Research Institute.

1 Scope

This section provides a method for determining vibration method paints, varnishes and related products density.

This section applies to all coatings, including thick slurry coatings. If you use compression devices, aerosols can be measured.

2 Normative references

The following documents contain provisions which, through reference GB/T 21862 in this section constitute provisions of this section. For dated reference documents Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 3186-2006 Paints, varnishes and raw materials for paints and varnishes - Sampling (ISO 15528:2000, IDT) GB/T 20777-2006 Paints and varnishes examination and preparation of samples (ISO 1513:1992, IDT) ISO 3696. 1987 laboratory use - Specification and test methods

3 Terms and Definitions

The following terms and definitions apply to this section.

The ratio of material quality and volume, expressed in grams per milliliter (g/mL).

Principle 4

The sample to be tested is placed on a glass or stainless steel U- shaped tube, and filled. The tube ends fixed, and begin to vibrate.

The vibration frequency of the sample tubes will be filled with different sample tube quality varies.

5 Temperature

5.1 relative filling properties, the effect of temperature on the density is large, and with the product type.

5.2 part of the provisions of 23 °C ± 0.5 °C as the standard temperature. In some specific cases, use other identification such as temperature measurement 20 °C ± 0.5 °C (see Appendix C).

5.3 Throughout the test, the sample tubes and the oscillator should be kept at a specific temperature, and should be tested to ensure that the entire Process, the change in temperature of no more than 0.5 °C.

6 Instruments

Routine laboratory equipment and glassware and the following instruments.