GB/T 15825.3-2008Sheet metal formability and test methods - Part 3: Drawing and drawing load test (English PDF)

Foreword

GB/T 15825 "Performance and test methods for sheet metal forming" is divided into eight sections.

--- Part 1. formability and indicators;

--- Part 2. General test procedures;

--- Part 3. drawing and drawing load test;

--- Part 4. reaming test;

--- Part 5. bending test;

--- Part 6. Cone cup test;

--- Part 7. Test lug;

--- Part 8. Forming Limit Diagram (FLD) Determination Guide.

This part of GB/T 15825 Part 3.

This Part replaces GB/T 15825.3-1995 "sheet metal forming and test methods - Drawing and drawing load test."

Section compared with the GB/T 15825.3-1995, major changes in the following.

--- Added "foreword";

--- "2 Normative references" added the introductory text;

--- Increasing the table name 2;

--- Modified 4.4.2.2, and 4.4.2.4 to 4.4.2.3 and 4.4.2.2 into using column item a) ~ c) statements The original

The provisions of 4.4.2.2 ~ 4.4.2.4;

--- Added "test temperature 4.4.4" and "5.4.4 Test temperature";

1 Scope

This section GB/T 15825 in the provisions of the LDR as an index sheet metal forming deep pull performance test methods, namely drawing test

Experience and drawing load test of two methods.

This section applies to a thickness of 0.45mm ~ 2.50mm of sheet metal, the relevant parties, may be appropriate to expand the applicable thickness range.

2 Normative references

The following documents contain provisions which, through reference GB/T 15825 in this section constitute provisions of this section. For dated reference documents

Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section

Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 15825.2-2008 sheet metal formability and test methods - Part 2. General test procedures 3 symbols, names and units The symbols used in this section, name and unit are shown in Table 1. Table 1 symbol, name and unit Symbol Name Unit Dd die diameter mm (D0) max Maximum specimen diameter mm A die Face (face) B clamping ring Face Fp drawing force N Fc BHF N Fcmin minimum BHF N LDR LDR A group of the same diameter of the sample, the number of specimens unruptured and ruptured the number of samples is equal to (all three), the trial of the group mm