GB/T 14328.1-1993Roughing end mill (English PDF)

Foreword

This standard is GB/T 14328.1-1993 "Straight Shank roughing end mill types and dimensions", GB/T 14328.2-1993 "flattened Roughing end mill shank types and dimensions ", GB/T 14328.3-1993" Morse taper shank roughing end mill types and dimensions " GB/T 14328.4-1993 "roughing end mills technical conditions" consolidated amendments.

This standard replaces GB/T 14328.1-1993, GB/T 14328.2-1993, GB/T 14328.3-1993, GB/T 14328.4-1993.

This standard and GB/T 14328.1-1993 compared to the main changes are as follows.

--- Modify the normative references;

--- Note to delete the original table, re-specified in 3.1.1;

--- Mark example made some changes.

1) to straight shank end mill roughing end mills;

2) GB/T 14328.1 to GB/T 14328-2008;

3) shank long series of roughing end mills increase labeled "long." this standard and GB/T 14328.2-1993 compared to the main changes are as follows.

--- Modify the normative references;

--- Note to delete the original table, re-specified in 3.2.1;

--- Mark example made some changes.

1) roughing end mill to Weldon shank roughing end mills;

2) GB/T 14328.2 to GB/T 14328-2008;

3) long series flatted parallel shank roughing end mills increase labeled "long." this standard and GB/T 14328.3-1993 compared to the main changes are as follows.

--- Modify the normative references;

--- Note to delete the original table, again in 3.3.1;

--- Mark example made some changes.

1) roughing end mill to Morse taper shank roughing end mills;

2) GB/T 14328.3 to GB/T 14328-2008;

3) long series of Morse taper shank roughing end mills increase labeled "long." this standard and GB/T 14328.4-1993 compared to the main changes are as follows.

--- Remove the performance test;

--- Signs and packaging made editorial changes.

The standard proposed by China Machinery Industry Federation.

This standard tool by the National Standardization Technical Committee (SAC/TC91) centralized.

This standard was drafted. Chengdu Tool Institute.

1 Scope

This standard specifies the straight shank roughing end mills, Weldon shank roughing end mills, Morse taper shank roughing end mill of the type and scale Inch, tag example, technical requirements, marking and packaging.

This standard applies to 6mm ~ 50mm diameter straight shank roughing end mills, diameter of 8mm ~ 63mm Weldon shank roughing End mills and diameter 10mm ~ 80mm Morse taper shank roughing cutter.

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 1443 from machine tools and tool handles with clip cone (GB/T 1443-1996, eqv ISO 296:1991) GB/T 6131.1 cutter straight shank - Part 1. General straight shank type and size (GB/T 6131.1-2006, ISO 3338-1.

1996, IDT)

GB/T 6131.2 cutter straight shank - Part 2. flatted straight shank type and size (GB/T 6131.2-2006, ISO 3338-2.

2000, MOD)

3 Type and size