GB/T 1149.5-2008Internal combustion engines -- Piston rings -- Part 5: Inspection measuring principles (English PDF)

Foreword

GB/T 1149 "Piston Ring" for the series of standards, divided into sixteen sections.

--- Part 1. General rules;

--- Part 2. Terminology;

--- Part 3. Material specifications;

--- Part 4. Quality requirements;

--- Part 5. Test methods;

--- Part 6. Cast wiper;

--- Part 7. rectangular cast iron ring;

--- Part 8. rectangular steel ring;

--- Part 9. trapezoidal cast iron ring;

--- Part 10. trapezoidal steel ring;

--- Part 11. Cast iron wedge ring;

--- Part 12. wedge-shaped steel ring;

--- Part 13. Oil ring;

--- Part 14. Spiral spring supporting oil ring;

--- Part 15. Cast iron spiral stays reed thin oil ring;

--- Part 16. strip combination oil ring.

This section GB/T 1149 Part 5.

This part identical with ISO 6621-2:2003 "Piston Ring Part 2. test methods" (in English).

This section is equivalent translation ISO 6621-2:2003 (English version).

For ease of use, this section made the following editorial changes.

--- "ISO 6621 this part" to "this Part";

--- Remove the foreword and introduction of international standards.

This part of ISO 6621-2:2003 and other international standards adopted, where the country has been adopted as a standard by our standards instead of phase Corresponding to international standards; our country has not been adopted as a standard, still direct use of international standards.

This part is GB/T 1149.6-1994 "Piston Ring test methods" revised, this part of the GB/T 1149.6-the main difference is 1994.

--- GB/T 1149.6-1994 is equivalent to ISO 6621-2. 1984, and the Department is divided into identical with ISO 6621-2:2003.

Since the implementation of this section instead of GB/T 1149.6-1994 "Piston Ring testing methods." this part is proposed by China Machinery Industry Federation.

This part of the internal combustion engine by the National Standardization Technical Committee (SAC/TC177) centralized.

1 Scope

This section GB/T 1149 specifies the test method for piston rings.

This section applies to a cylinder diameter of less than or equal to 200mm reciprocating internal combustion engines and compressors work under similar conditions of living Ring.

2 Normative references

The following documents contain provisions which, through reference to GB/T 1149 to the present, constitute provisions of this section. For dated reference documents Member, all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouraged to reach under this section Parties to research agreement to use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 3505 Geometrical product specification the term structure of the surface contours of the surface structure of the law, definitions and parameters (GB/T 3505-2000, eqv ISO 4287:1997) GB/T 4340.3-1999 Vickers hardness test - Part 3. Calibration of hardness blocks (idt ISO 6507-3:1997)

2007 The first part of the internal combustion engine piston ring 1.. ISO 6621-1 term ISO 4287-1. 1984 Surface roughness - Terminology - Part 1. Surface and its parameters

3 Terms and Definitions

Terms and definitions used in this section in accordance with the provisions of ISO 6621-1.

4 Test methods