GB 16487.9-2017Environmental protection control standard for imported solid wastes as raw materials -- Waste wires and cables (English PDF)

Foreword

In order to carry out the "Law of the People's Republic of China on Prevention and Control of Environmental Pollution by Solid Wastes", "Prevention and Control of Radioactive Pollution by the People's Republic of China Law "and other laws and regulations to control imports of raw materials as waste wire and cable caused by environmental pollution, the development of this standard.

This standard specifies the import of waste wire and cable environmental protection control requirements.

This standard is one of the series of control standards for imported solid waste environmental protection, applicable to the import of solid waste can be used as raw materials Catalog on the import of waste wire and cable management.

This standard was first released in 1996, the first revision in 2005, this is the second revision.

The main content of this revision.

- Increased the requirement of external radiation penetration of imported waste wire and cable;

- Adjusted hazardous waste control requirements;

- tightened control requirements for general inclusions;

- revised inspection requirements.

From the date of the implementation of this standard, "Imported as raw materials for solid waste environmental protection control standards - waste wire and cable" (GB 16487.9-2005) abolished.

This standard was revised by the Ministry of Environmental Protection Soil and Environmental Management Division, Science and Technology Standards Division.

This standard is mainly drafted by. China Academy of Environmental Sciences.

This standard MEP approved on December 29, 2017.

This standard since March 1, 2018 implementation.

This standard is interpreted by the MEP.

Import can be used as raw material for solid waste environmental protection control standards Waste wire and cable

1 Scope of application

This standard specifies the import of waste wire and cable environmental protection control requirements.

This standard applies to the following waste wire and cable import management.

Customs Product Code Solid Waste Name

7404000010 Recycling copper-based waste wire and cable

7602000010 Recycled aluminum wire, cable

2 Normative references

This standard references the following documents in the terms. For undated references, the effective version applies to this standard.

GB 5085.1 hazardous waste identification standard corrosive identification GB 5085.2 Hazardous Wastes Identification Standard Acute Toxicity Screening GB 5085.3 hazardous waste identification standard leaching toxicity identification GB 5085.4 Hazardous Waste Identification Standard Flammability Identification GB 5085.5 hazardous waste identification standard reactive identification GB 5085.6 Hazardous Waste Identification Standard Toxic substance content identification SN/T 0570 Import can be used as raw materials waste radioactive contamination inspection procedures SN/T 1791.7 Waste Inspection and Quarantine Procedures for Imported Use of Raw Materials - Part 7. Waste Wire & Cable "National List of Hazardous Wastes" (Ministry of Environmental Protection, National Development and Reform Commission, Ministry of Public Security Order No. 39)

3 Terms and definitions

The following terms and definitions apply to this standard.

4 Control standards and requirements

4.1 Radioactive waste imported wire and cable pollution control should meet the following requirements.

a) Waste wire and cable are not mixed with radioactive waste;

b) The external radiation penetration rate of waste wire and cable (including packaging) does not exceed the normal natural Radiation background value 0.25 µGy/h;

c) The radioactive contamination of alpha, beta radioactive contamination on the surface of waste wire and cable is. Maximum detection water of 300 cm2 at any part of the surface the flat average alpha does not exceed 0.04 Bq/cm2 and beta does not exceed 0.4 Bq/cm2;

d) The specific activity of radionuclides in scrap wire and cable should be less than the limits in Table 1.

Table 1 radionuclide specific activity limits

Nuclide specific activity (Bq/g) Beta-gamma mixture of unknown ingredients 0.3 Alpha mixture of unknown ingredients 0.1 4.2 waste wire and cable are not mixed with abandoned bombs, shells and other explosive weapons ammunition.

4.3 Waste wire and cable should be strictly limited inclusion of the following inclusions, the total weight should not exceed 0.01% of the weight of waste wire and cable.

a) airtight container;

b) oil seal cables, optical cables, lead sheath cables;

c) Wastes from the National List of Hazardous Wastes;

d) based on GB 5085.1 ~ GB 5085.6 identification criteria for identification, where corrosive, toxic, flammable, anti-Other Hazardous Wastes with One or More Hazardous Characteristics

4.4 In addition to the wastes listed in the above articles, other inclusions (including waste paper, wood waste, waste glass Waste, etc.) mixed, the total weight should not exceed 0.5% of the weight of imported waste wire and cable.

5 Test

5.1 The standard test to take a random sample test approach to the import of waste containers shipped to take out of the box, dig box, unpacking /Bundles, sorting method of inspection, the bulk of imported waste by sea to open inspection and landing inspection methods, the bulk of land of imported waste to take out of the box inspection and floor inspection methods, if necessary, sent to the laboratory for testing (including radionuclide ratio Activity, hazardous characteristics, etc.). The results of random sampling test as a whole lot of goods inspection results.

5.2 The standard 4.1 test in accordance with the provisions of SN0570.

5.3 This standard 4.3d) in accordance with the provisions of GB 5085.1 ~ GB 5085.6 test method.

5.4 The other provisions of this standard test in accordance with SN/T 1791.7 regulations.