FZ/T 93019-2004Flat fillet clothing for carding process (English PDF)

Foreword

This Standard replaces FZ/T 93019-1993 Flat clothing for carding process.

Compared with FZ/T 93019-1993, the major changes of this Standard are as

follows.

— MODIFY the name of this Standard.

— ADD the "Normative references" (SEE Chapter 2 of this version).

— ADD the "Terms and definitions" (SEE Chapter 3 of this version).

— MODIFY the "Classification and marks" (Section 3.1 of the 1993 version;

Sections 4.1 and 4.2 of this version).

— SIMPLIFY the requirements for the limit deviations of the basic

dimensions of the flat clothing. DELETE the grading rules (Section 4.1

of the 1993 version; Section 5.1 of this version).

— MODIFY the requirements for the tip flatness. DELETE the grading

rules (Section 4.2 of the 1993 version; Section 5.2 of this version).

— DELETE the requirements for the distance between carding pin and

side clip (Section 4.3 of the 1993 version).

— MODIFY the provisions on the tip hardness range of the carding pins.

DELETE the grading rules (Section 4.4 of the 1993 version; Section 5.3

of this version).

— SIMPLIFY the test methods. DELETE the appendix (Section 5.1 of the

1993 version; Sections 6.1 to 6.5 of this version).

— MODIFY and IMPROVE the "Inspection rules" (Chapter 6 of the 1993

version; Chapter 7 of this version).

— MODIFY the "Packaging, symbols and storage" (Chapter 7 of the 1993

version; Chapter 8 of this version).

This Standard was proposed by China National Textile and Apparel Council.

This Standard shall be under the jurisdiction of the Shaanxi Textile Equipment

Research Institute.

Main drafting organizations of this Standard. Shaanxi Textile Equipment

Research Institute, Shanghai Far East Card Clothing Co., Ltd, Wuxi Owl

Flat fillet clothing for carding process

1 Scope

This Standard specifies the terms, definitions, classification, marks,

requirements, test methods, inspection rules, symbols, packaging and

storage of the flat fillet clothing for carding process (hereinafter referred to as

"flat clothing").

This Standard is applicable to the flat clothing using the fillet clothing as

carding element.

2 Normative references

The provisions in the following documents become the provisions of this

Standard through reference in this Standard. For dated references, the

subsequent amendments (excluding corrections) or revisions do not apply to

this Standard. However, parties who reach an agreement based on this

Standard are encouraged to study if the latest versions of these documents

are applicable. For undated references, the latest versions apply to this

Standard.

GB/T 191 Packaging – Pictorial marking for handling of goods

GB/T 347 Card wire

GB/T 2828.1 Sampling procedures for inspection by attributes – Part 1.

Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot

inspection

GB/T 2829 Sampling procedures and tables for periodic inspection by

attributes (Apply to inspection of process stability)

GB/T 4340.1 Metallic materials – Vickers hardness test – Part 1. Test

method

GB/T 4892 Dimensions of rigid rectangular packages – Transport

packages

GB/T 6543 Corrugated boxes

GB/T 12339 Inner packaging materials in preservation

6 Test methods

7 Inspection rules