YS/T 560-2007sting aluminium anodic bar (English PDF)

Foreword

Instead of the standard YS/T 560-2006 "aluminum ingot." this standard YS/T 560-2006 compared to the main changes are as follows.

--- Standard name was changed to "cast aluminum anode rod";

--- Standard range "Made with cables and conducting" to "conducting with";

--- Increasing the size 130 × 135;

--- Appearance quality, low magnification re provisions;

--- Chemical composition sampling method according to the provisions of GB/T 17432 were;

--- Chemical analysis method according to the provisions of GB/T 20975 or GB/T 7999 will be;

--- Macrostructure examined according to the provisions of GB/T 3246.2 performed.

This standard by the National Standardization Technical Committee of non-ferrous metals and centralized.

This standard by the Aluminum Corporation of China Guizhou Branch is responsible for drafting.

1 Scope

This standard specifies requirements for cast aluminum anode rod, test methods, inspection rules, marking, packaging, transportation, storage and contract.

This standard applies to cast aluminum anode rod (hereinafter referred to as the guide bar).

2 Normative references

The following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard.

GB/T 1196 aluminum ingots for remelting GB/T 3246.2 Wrought aluminum and aluminum alloy products low fold inspection method GB/T 20975 (all parts), chemical analysis of aluminum and aluminum alloys GB/T 7999 aluminum and aluminum alloys Optical emission spectroscopy method GB/T 17432 Wrought aluminum and aluminum alloy chemical analysis sampling method

3 Requirements