SN/T 2361.1-2009Safe code of packagings for import and export dangerous goods. Part 1: Limited quantities (English PDF)

4.1 General

A limited number of each is the maximum number of transport-related content or material goods loaded in a limited number of all kinds of dangerous goods requirements, see "On Recommendations on the Transport of Dangerous Goods Model Regulations" Chapter 3.2. Dangerous Goods List.

4.2 dangerous goods packaging containers generally require the use of

4.2.1 Dangerous goods shall be packed in good quality packagings, including IBCs and large container, the container should be strong enough to withstand the During transport the shocks and loadings normally encountered, including between transport means and between transport units and warehouses reproduced, as well as removal from a pallet or Overpack for subsequent manual or mechanical handling. Possible under normal conditions of transport by vibration or due to temperature, humidity or pressure change during transport (Altitude, for example) is caused by loss of contents, the container including structural and closed IBCs and large packagings shall be prevented any loss of contents. Container, including IBCs and large packagings shall be in accordance with the information provided by the manufacturer closed. Shall during transport no dangerous residue was adhered to, IBCs and large containers outside of the container. These provisions apply, as appropriate, to new, reused, Reconditioned or remanufactured packagings, and to new, reused, repaired or remanufactured IBCs and large new or reused container.

4.2.2 container, including IBCs and large containers in various parts in direct contact with dangerous goods, should meet the following conditions.

a) shall not be affected by the strength or dangerous goods is significantly weakened dangerous goods;

b) shall not cause a dangerous effect in packages, for example to promote react with dangerous goods or dangerous goods react. When necessary, this these parts should be appropriate inner coating or appropriately treated.

4.2.3 If the container, including IBCs and large packagings contents are liquid, it should allow sufficient ullage to ensure no due Liquid temperature changes that may occur during transport caused by the expansion of the packaging leakage or permanent deformation. Unless specific requirements are prescribed, Otherwise, the liquid may not fill the container at a temperature of 55 °C. But IBCs should allow sufficient ullage to ensure that the overall average temperature