GB/T 6115.4-2014Series capacitors for power systems -- Part 4: Thyristor-controlled series capacitors (English PDF)

Foreword

GB/T 6115 "Series capacitors for power systems" is divided into four parts.

--- Part 1. General;

--- Part 2. Protective equipment for series capacitor banks;

--- Part 3. Internal fuses;

--- Part 4. Thyristor controlled series capacitor.

This section GB/T 46115 Part of.

This section drafted in accordance with GB/T 1.1-2009 given rules.

This section uses redrafted law revision using IEC 60143-4:2010 "Series capacitors for power systems - Part 4. Thyristor controlled Made a series capacitor. " this part of IEC 60143-4:2010, compared with more adjustment in the structure, listed in Appendix A of this part of IEC 60143-4.

Article 2010 of chapter numbering control list.

Technical differences exist compared to 2010, the terms of these differences has been involved through its outer margins. This portion of the IEC 60143-4 Vertical single-line position (|) were marked.

This part of IEC 60143-4:2010 technical differences and their reasons are as follows.

--- Increased "resistance capacitor shell burst energy test" in 7.2.4 special test;

--- Added missing in the IEC 60143-4 normative references;

--- Increase the limit voltage Ulim terms and definitions (see 3.2.34);

--- The nominalreactance modify ratedreactance (see 3.2.29);

--- Added three abbreviations (see 3.1).

MOV. MOV device (MetalOxideVaristor);

TCSC. thyristor controlled series capacitor banks (Thyristor-ControledSeriesCapacitorBank);

TE. thyristor electronic device (ThyristorElectronics).

This section also made the following editorial changes.

--- According to the rules GB/T 1.1-2009 given some written format and layout has been modified;

--- "This standard" be replaced by "this section";

"." --- With a decimal point instead of the original IEC standard as a decimal comma ",";

--- Remove the IEC 60143-4:2010 Foreword;

--- Added Appendix A "in this section with IEC 60143-4:2010 compared to structural changes";

--- Modify the IEC 60143-4:2010 in the editorial errors.

a) Figure 1 "2 --- switch module or switch-level" and "8 --- when the need for additional switching stage" not shown in the drawings, this section Revised Figure 1, identified in Figure 1 a "2" and "8" (see Figure 1);

b) 8.1e) in the "IHM" error, should be "HMI", this section is amended as "HMI".

This part is proposed by the China Electrical Equipment Industrial Association.

This part of the National Standardization Technical Committee Power capacitor (SAC/TC45) centralized.

This section is drafted. Xi'an High Voltage Apparatus Research Institute Co., Ltd., Puri Power Technology Co., Ltd. Xi'an Electric Power Capacitor Limited liability company, Xi'an Electric Power Systems Ltd., Zhejiang Jiang Guirong harmonic level technology limited liability company, limited Guilin Power Capacitor Ltd., Shanghai Siyuan Electric Power Capacitor Co., Ltd., and Shenzhen City Power Technology Co., Ltd., Shenzhen City & Poor's Shun Technology Co., Zi Bleomycin Po Power Capacitor Co., Ltd., Tianjin opened Electric Co., Ltd., Qingdao Hengshun Electric Co., Ltd., Shijiazhuang Development Zone Wave Acer Technology Co., Ltd., Zhejiang Electric Power Company Electric Power Research Institute, Shandong Taikai Power Electronic Co., Ltd.

Drafters of this section. Meng Ying, Tian Enwen, Daizhao Bo, sworn room, Zhao Xin, HE tide, Yanhuan Ling, Lin Yue Wang, Liu Jing, Wang Yu Jing, Zhao Liang, Zhou Xiaoqin, Louyan Tao, Liang Chen, Zuo Qiang Lin, Chong Hu, Lu Tao, Zhang Jian call, Ma Feng, high-Yi, the history of the ocean, Jia Baojun, Jinyong Tao, Zhu Wenqing, high-growth country.

Series capacitors for power systems Part 4. Thyristor controlled series capacitor

1 Scope

GB/T 6115 provisions of this section apply to the transmission line in series thyristor controlled series capacitor (referred to as the TCSC) devices Design and testing.

This section applies to the thyristor valve, capacitors, reactors of TCSC TCSC rated parameters and control characteristics, protection features, cold but the system and the system is running.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version suitable for use herein Member. For undated references, the latest edition (including any amendments) applies to this document.

GB 311.1 insulation coordination - Part 1. Definitions, principles and rules (GB 311.1-2012, IEC 60071-1:2006, MOD) GB/T 311.2 insulation coordination - Part 2. Guidelines for the use (GB/T 311.2-2013, IEC 60071-2:1996, MOD) GB 1094.1-1996 Power transformers - Part 1. General (EQVIEC 60076-1.1993) GB/T 1094.6-2011 Power transformers - Part 6. Reactors (IEC 60076-6:2007, MOD) GB/T 2421.1 electric and electronic products environmental testing Overview and Guide (GB/T 2421.1-2008, IEC 60068-1. 1988, IDT) GB/T 2423.2 Environmental testing for electric and electronic products Part 2. Test methods Test B. Dry heat (GB/T 2423.2-2008, IEC 60068-2-2:2007, IDT) GB/T 2423.3 Environmental testing for electric and electronic products Part 2. Test methods - Test Cab. Damp heat test (GB/T 2423.3-2006, IEC 60068-2-78:2001, IDT) GB/T 2900.16 Electrotechnical terminology - Power capacitors [GB/T 2900.16-1996, NEQIEC 60050 (436).1990] GB/T 6115.1-2008 Series capacitors for power systems - Part 1. General (IEC 60143-1:2004, MOD) GB/T 6115.2-2002 Series capacitors for power systems - Part 2. Protective equipment for series capacitor banks (IEC 60143-2:1994, IDT) GB/T 6115.3-2002 Series capacitors for power systems - Part 3. Internal fuses (IEC 60143-3:1998, IDT) GB/T 7354 partial discharge measurements (GB/T 7354-2003, IEC 60270:2000, IDT) GB/T 11287 Electrical relays - Part 21. Vibration measuring relays and protection equipment, shock, bump and seismic tests Section 1. Vibration tests (sinusoidal) (GB/T 11287-2000, IEC 60255-21-1. 1988, IDT) GB/T 14537 and measure impact crash test (GB/T 14537-1993 relays and protection equipment, idt IEC 60255-21-2. 1988) GB/T 14598.3 Electrical relays - Part 5. Measuring relays and protection equipment insulation coordination requirements and tests (GB/T 14598.3-2006, IEC 60255-5:2000, IDT) GB/T 16927.1 High-voltage test techniques - Part 1. General definitions and test requirements (GB/T 16927.1-2011, IEC 60060-1:2006, MOD) GB/T 17626 (all parts), electromagnetic compatibility test and measurement technology [IEC 61000-4 (alparts)] 1)

1) The addition of the IEC 60143-4 standard for the missing standards, has been transformed into a national standard.