GB/T 40998-2021Determination of hydroxypropyl content in modified starch—Spectrophotometric method (English PDF)
变性淀粉中羟丙基含量的测定 分光光度法
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 40998-2021 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
November 26, 2021
Implementation date
June 1, 2022
Scope
GB/T 40998-2021 is the English-translated version of 变性淀粉中羟丙基含量的测定 分光光度法.
GB/T 40998-2021 is the Chinese national spectrophotometric method for measuring the hydroxypropyl content of modified starch. In concentrated sulfuric acid the hydroxypropyl groups are converted to propylene glycol and then to propionaldehyde and propenol, which form a purple complex with ninhydrin; the absorbance of the complex is read at 590 nm.
The standard lists the reagents and materials, including sulfuric acid, ninhydrin hydrate and sodium hydrogensulfite, the instruments, the preparation of the sample and blank starch solutions, the standard curve and the determination, with notes on timing, heating and mixing, followed by the interpretation of results and precision.
It applies to modified starches containing hydroxypropyl groups and is used by starch producers and food testing laboratories. It was issued on 26 November 2021 and has applied since 1 June 2022.
Found what you need?
Document preview — GB/T 40998-2021
National Standard of the People's Republic of China
- ICS
- 67.180.20
- Classification
- X 11
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Foreword3
- 1 Scope4
- 2 Normative references4
- 3 Principle4
- 4 Reagents and materials4
- 5 Instruments5
- 6 Operating methods5
- 7 Interpretation of results7
- 8 Precision7
1 Scope
This document specifies a spectrophotometric method for the determination of hydroxypropyl content in modified starch.
This document applies to modified starches containing hydroxypropyl.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition corresponding to that date is applicable to this document; for undated references, the latest version (including all amendments) is applicable to this document.
GB/T 601, Chemical reagent - Preparations of reference titration solutions
GB/T 6682, Water for analytical laboratory use - Specification and test methods
3 Principle
The modified starch containing hydroxypropyl is oxidized to form propylene glycol in concentrated sulfuric acid medium, and propylene glycol is further dehydrated to form propionaldehyde and propenol. Propionaldehyde and propenol form a purple complex with ninhydrin in concentrated sulfuric acid medium. By measuring the absorbance of the complex at 590 nm, obtain hydroxypropyl content through calculation.
4 Reagents and materials
Unless otherwise specified, the reagents used shall be analytical reagents. The water used for the test shall meet the requirements for class-II water specified in GB/T 6682.
4.1 Sulfuric acid (H2SO4): guaranteed reagent, purity >=98%, well sealed.
4.2 Ninhydrin hydrate (C9H6O4).
4.3 Sodium hydrogensulfite (NaHSO3). […]
6 Operating methods
6.3 Determination
6.3.1 Take 1 mL of each of the standard series working solutions (6.1.2); transfer them into 25 mL graduated test tubes with stoppers respectively; place the test tubes in an ice-water bath; add 8 mL of sulfuric acid (4.1) dropwise accurately and slowly. After mixing, accurately heat in a boiling water bath for 3 min; then, immediately move the test tube into an ice-water bath to cool down. Carefully add 0.60 mL of ninhydrin hydrate solution (4.5) along the wall of the test tube; shake it up immediately; keep it in a water bath at 25 °C for 100 min. Use sulfuric acid (4.1) to dilute the volume to 25 mL in each test tube; invert the test tube several times to mix (do not shake); after standing for 5 minutes, immediately transfer part of the solution into a 1 cm colorimetric cell of the spectrophotometer; measure the absorbance value at 590 nm; draw a standard curve according to the absorbance value.
Note 1: Add 8 mL of sulfuric acid dropwise; accurately measure the volume and add slowly. The function of adding 8 mL of sulfuric acid for the first time is to dehydrate propylene glycol to form propionaldehyde and propenyl alcohol; control the rate of addition; mix from time to time to prevent side reactions.
Note 2: Use sulfuric acid to fix the volume in each test tube to 25 mL; at this time, add sulfuric acid along the wall of the tube; invert the test tube to mix, to prevent damage to the complex formed by propionaldehyde, propenyl alcohol and ninhydrin.
Note 3: Sulfuric acid should be sealed in time after use to prevent changes in purity from affecting the measured value.
Note 4: "Accurate heat in the boiling water bath for 3 minutes", the boiling water bath time is strictly controlled to ensure uniform heating; if there are multiple samples or parallel, ensure that the boiling water bath time for each test tube […]
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Similar standards
How to Download GB/T 40998-2021
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 601-1988 — Chemical reagent--Preparations of standard volumetric solutions
GB/T 601-2002 — Chemical reagent - Preparations of standard volumetric solutions
GB/T 601-2016 — Chemical Reagent - Preparations of Standard Volumetric Solutions
GB/T 40998-2021
$90.00