GB/T 39564.1-2020Multi-carrier shared distribution infrastructure for fibre to the home—Part 1: Optical cable cross-connect cabinet (English PDF)

1 Scope

This part of GB/T 39564 specifies the requirements of fiber-to-the-home fiber-to-the-home multi-telecommunications service operators in the common wiring facility

Composition, classification and naming, requirements, test methods, inspection rules and marking, packaging, transportation and storage:

This section applies to fiber-to-the-home fiber optic cable junction boxes for multiple telecommunication business operators to access together, and for other scenarios for multiple

The optical cable transfer box commonly used by telecom business operators can also be used as a reference:

Note: Refer to Appendix A for the selection guide of fiber to the home wiring facilities:

2 Normative references

The following documents are indispensable for the application of this document: For dated reference documents, only the dated version applies to this article

Pieces: For undated references, the latest version (including all amendments) applies to this document:

GB/T 2423:1 Environmental testing of electrical and electronic products Part 2: Test methods Test A: Low temperature

GB/T 2423:2 Environmental testing of electric and electronic products Part 2: Test method Test B: High temperature

GB/T 2423:4 Environmental testing of electrical and electronic products Part 2: Test method Test Db: Alternating damp heat (12h 12h cycle)

GB/T 2423:10 Environmental Test Part 2: Test Method Test Fc: Vibration (Sine)

GB/T 2423:17 Environmental testing of electrical and electronic products Part 2: Test method Test Ka: Salt spray

GB/T 2828:1 Sampling inspection procedure by attributes Part 1: Batch inspection sampling plan retrieved by acceptance quality limit (AQL)

GB/T 3873 General technical conditions for packaging of communication equipment products

GB/T 4208-2017 Enclosure protection grade (IP code)

GB/T 5095:2-1997 Basic test procedures and measurement methods for electromechanical components for electronic equipment Part 2: General inspection, electrical

Continuity and contact resistance test, insulation test and voltage stress test

GB/T 5169:5-2020 Fire hazard test of electric and electronic products Part 5: Test flame needle flame test method device,

Confirmation test methods and guidelines

GB/T 9286-1998 Cross-cut test of paint and varnish film

GB/T 15568 General-purpose sheet molding compound (SMC)

GB/T 18380:12 Cable and optical cable burning test under flame conditions Part 12: Single insulated wire and cable flame vertical

Spread test 1kW premixed flame test method

GB/T 26125 Determination of six restricted substances in electrical and electronic products (lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls and polybrominated diphenyl ethers)

GB/T 26572 Limit requirements for restricted substances in electronic and electrical products

GB 50846-2012 Code for design of fiber-to-the-home communication facilities in residential areas and residential buildings

GA/T 73-2015 Mechanical anti-theft lock

YD/T 1272 (all parts) optical fiber connector

YD/T:2000:1 Planar Optical Waveguide Integrated Optical Circuit Device Part 1: Optical Power Splitter Based on Planar Optical Waveguide (PLC) […]