Valid

GB/T 38480-2020Determination of antifungal activity for microbial secondary metabolites—Mycelial growth rate method (English PDF)

微生物源抗生素类次生代谢产物抗真菌活性测定 菌丝生长速率法

Preview PDF

This is a limited preview

Buy now to download the full PDF (15 pages)

Need quotation for your management?

Get a formal quotation for GB/T 38480-2020 in 30 minutes.

Issued by

SAMR; SAC

Level / Type

National · Recommended

Issue date

November 19, 2020

Implementation date

November 19, 2020

Scope

GB/T 38480-2020 is the English-translated version of 微生物源抗生素类次生代谢产物抗真菌活性测定 菌丝生长速率法.

GB/T 38480-2020 is the Chinese standard "Determination of antifungal activity for microbial secondary metabolites - Mycelial growth rate method". Its scope clause reads: This Standard specifies a method for determining the antifungal activity of secondary metabolites of antibiotics derived from microorganisms by the mycelial growth rate method.

This Standard applies to the determination of antifungal activity of secondary metabolites of antibiotics derived from microorganisms. Its clauses include terms and definitions; principal; reagents and materials; apparatus; operation procedures; calculation of the results; repeatability.

It was issued by the State Administration for Market Regulation on NOVEMBER 19, 2020 and took effect on NOVEMBER 19, 2020.

Found what you need?

Document preview — GB/T 38480-2020

National Standard of the People's Republic of China

ICS
07.080
Classification
A 21

Issued by: State Administration for Market Regulation; Standardization Administration of the PRC

Contents

  • Foreword3
  • 1 Scope4
  • 2 Normative References4
  • 3 Terms and Definitions4
  • 4 Principal4
  • 5 Reagents and Materials5
  • 6 Apparatus5
  • 7 Operation Procedures5
  • 8 Calculation of the Results6
  • 9 Repeatability7

1 Scope

This Standard specifies a method for determining the antifungal activity of secondary metabolites of antibiotics derived from microorganisms by the mycelial growth rate method.

This Standard applies to the determination of antifungal activity of secondary metabolites of antibiotics derived from microorganisms.

2 Normative References

The following documents are essential to the application of this document. For the dated documents, only the versions with the dates indicated are applicable to this document; for the undated documents, only the latest version (including all the amendments) is applicable to this document.

GB/T 6682 Water for Analytical Laboratory Use - Specification and Test Methods

3 Terms and Definitions

For the purposes of this document, the following terms and definitions apply.

3.1 Median inhibitory concentration; IC50

The concentration at which the inhibition rate of fungal growth reaches 50%.

3.2 Antifungal activity

The ability to resist the growth and reproduction of fungi.

4 Principal

Mix the tested secondary metabolites with the culture medium; use the growth rate of the colonies on the culture medium to measure the ability of the secondary metabolites to inhibit filamentous fungi, and judge the activity by calculating IC50.

7 Operation Procedures

7.2 Preparation of tested samples

The polar sample is directly dissolved in water (the non-polar sample is fully dissolved by adding a certain concentration of surfactant); prepare it into a certain concentration of mother liquor; filter through a sterile 0.45µm filter membrane. And then use the sterile water (or the corresponding surfactant) to dilute step by step by 2 times or 5 times concentration to prepare at least 5 different concentrations of the tested solution. When diluting step by step, ensure that there is concentration point with the inhibition rate greater than 50% distribution, and there is also concentration point with the inhibition rate less than 50% distribution; prepare immediately before use.

7.3 Preparation of test plate

Respectively dilute the tested samples prepared in 7.2 with the PDA medium cooled to 55°C±1°C at a ratio of 1:9; mix well and transfer 10 mL each with a sterile pipette to a sterile petri dish; gently shake the petri dish to make it evenly flat. After it has solidified, it shall be made into a test plate. The plate prepared by mixing the corresponding solvent and PDA is used as a blank control plate for later-use.

7.4 Determination of antibacterial activity

Use a sterile punch (inner diameter of 5mm±0.1mm) to punch holes in the same radius edge of the activated indicator bacteria plate; and use sterile forceps to take the bacterial cake and place it in the middle of the detection plate prepared in 7.3. Each treatment is repeated for 5 times. Place the plate in a constant temperature incubator at 28°C±1°C for 24h~48h, take it out; and measure the colony diameter by the cross method. The average value of two measurements is the colony diameter.

8 Calculation of the Results

The inhibition rate is calculated according to Formula (1):

Where: I - inhibition rate;

D1 - diameter of colony formed in the blank control plate, in mm;

D2 - diameter of colony formed in the tested secondary metabolite plate, in mm.

Take the average of five parallel samples as the final result, and keep the calculated result to two digits after the decimal point. […]

......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.

Referenced standards

Similar standards

How to Download GB/T 38480-2020

  1. 1

    Add to cart

    Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.

  2. 2

    Checkout

    Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).

  3. 3

    Fast delivery

    After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.

  4. 4

    Invoice included

    A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.

Related Standards

English PDF
15 pages
Fast delivery
Invoice included
View Cart

Secure payment via Stripe

Payments accepted

VisaMastercardAmerican ExpressApple PayGoogle PayStripe

GB/T 38480-2020

$85.00