GB/T 37891.3-2019Cutter arbors with parallel key and tenon drive -- Part 3: Dimensions and designation of tool holders with 7/24 taper for automatic tool changers (English PDF)

7.24 automatic tool changer taper shank size and marking.

The technical differences between this part and ISO 10649-3.2013 and their reasons are as follows.

---About the normative reference documents, this section has made technical adjustments to adapt to China's technical conditions, adjustments

It is concentrated in Chapter 2, "Regulatory References", and the specific adjustments are as follows.

* Replace ISO 2768-2 with GB/T 1184 equivalent to the international standard;

* Replace ISO 2768-1 with GB/T 1804 equivalent to the international standard;

* Replace ISO 7388-1 with GB/T 10944.1 equivalent to the international standard;

* Replace ISO 7388-2 with GB/T 10944.2 equivalent to the international standard;

* Replace ISO 2780 with GB/T 20329 equivalent to the international standard;

* Replace ISO 10649-1 with GB/T 37891.1 modified to adopt international standards;

* Replace ISO 10643 with GB/T 37895 modified to international standards.

--- According to the actual situation in the country, the drawing method of the bolts in Fig. 1 and Fig. 2 was modified.

This section has made the following editorial changes.

--- According to the actual situation, edited the table 2;

--- Removed references to international standards.

This part was proposed by the China Machinery Industry Federation.

This part is under the jurisdiction of the National Tool Standardization Technical Committee (SAC/TC91).

This section drafted by. Chengdu Tool Research Institute Co., Ltd., Sichuan Tianhu Tools Co., Ltd., Tyson Yingge (Chengdu) CNC knife

With a company limited by shares.

3.1 General provisions

All dimensions and tolerances are in millimeters, unmarked linear and angular dimensional tolerances are in accordance with GB/T 1804 "m", unfilled shape

And position tolerance according to the "k" level of GB/T 1184.

The interchangeable dimensions of the milling cutter on the milling cutter are in accordance with the provisions of GB/T 20329, and the dimensions of the fastening bolts are in accordance with GB/T 37895.

The cutter cutter tool interface size with flat key and end key drive is as specified in GB/T 37891.1.

The diagram is only a schematic diagram, does not represent the design diagram, just gives the dimensions that need to be met.

See Appendix A for the relationship between the dimensional symbols in this section and the symbols in the ISO 13399 series of standards.

3.2 with 7.24 automatic tool changer taper shank in accordance with GB/T 10944.1

The dimensions of the 7.24 automatic tool changer with shank conforming to GB/T 10944.1 are shown in Figure 1 and Table 1.