GB/T 37752.1-2019Industrial furnaces and associated processing equipment -- Safety -- Part 1: General requirements (English PDF)

Foreword

GB/T 37752, Industrial furnaces and associated processing equipment - Safety, is

divided as follows.

— Part 1.General requirements.

This Part is Part 1 of GB/T 37752.

This Part is drafted in accordance with the rules given in GB/T 1.1-2009.

This Part is identical to ISO 13577-1.2016 Industrial furnaces and associated

processing equipment - Safety - Part 1.General requirements by using the translation

method.

See Annex NA for Chinese documents that have consistent correspondence with the

international documents normatively referenced in this Part.

This Part makes the following editorial changes.

— Change the unit "gal" in 4.1.2 to "cm/s2";

— Change the unit "bar" to "Pa";

— Add the informative annex NA.

This Part was proposed by China Electrical Equipment Industry Association.

This Part shall be under the jurisdiction of the National Technical Committee on

Industrial Electro-heat Equipment of Standardization Administration of China

(SAC/TC 121).

Drafting organizations of this Part. Xi'an Electric Furnace Institute Co., Ltd.,

Chongqing CISDI Thermal & Environmental Engineering Co., Ltd., Shaanxi

Hongxinyuan Metallurgical Equipment Industry Co., Ltd., Henan Tianli Thermal

Equipment Co., Ltd., Zhuzhou Electric Cooker Factory, National Center for Quality

Supervision and Test of Electric Furnace, Xi'an Flit Heat Treatment Co., Ltd.

Main drafters of this Part. Ge Huashan, Li Kun, Yu Weijiang, Cheng Shuming, Li

Mingke, Yang Zhen, Yan Xianbin, Zhang Yongwu, Yuan Fanglan, Yang Jia.

Industrial furnaces and associated processing equipment -

Safety - Part 1.General requirements

1 Scope

This Part of GB/T 37752 specifies the general safety requirements common to industrial

furnaces and associated processing equipment (TPE).

2 Normative references

The following documents are referred to in the text in such a way that some or all of

their content constitutes requirements of this document. For dated references, only the

edition cited applies. For undated references, the latest edition of the referenced

document (including any amendments) applies.

ISO 12100.2010, Safety of machinery - General principles for design - Risk

assessment and risk reduction

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 12100 and

ISO 13574 apply.

4 Safety requirements and/or protective measures

The manufacturer shall maintain evidence that all safety requirements of the design

have been fulfilled.

5 Verification

Proof of compliance of the safety requirements and/or protective measures shall be

demonstrated by any one, or a combination, of the following.

6 Information for use

With this in view, it shall inform and warn the operator; the supervisor shall be notified

and warned of residual risks.

Requirements concerning where signals and warning devices shall be fitted are given

in Clause 4.

Annex A

(Informative)

List of significant hazards

This annex lists all significant hazards, hazardous situations and events, as far as they

are dealt with in this document, that are identified by risk assessment as significant for

this type of equipment and that require action to eliminate or reduce the risk. The

following significant hazards can occur in the use of TPE.

......