GB/T 35876-2018Inspection of grain and oils—Determination of sodium,mgnesium, kalium, calcium, chromium, manganese, iron, copper, zinc, arsenic, selenium, cadmium and plumbum in cereals and derived products—Iductively cupled pasma-mss sectrometric method (English PDF)
粮油检验 谷物及其制品中钠、镁、钾、钙、铬、锰、铁、铜、锌、砷、硒、镉和铅的测定 电感耦合等离子体质谱法
This is a limited preview
Buy now to download the full PDF (15 pages)
Need quotation for your management?
Get a formal quotation for GB/T 35876-2018 in 30 minutes.
Issued by
SAMR; SAC
Level / Type
National · Recommended
Issue date
February 6, 2018
Implementation date
September 1, 2018
Scope
GB/T 35876-2018 is the English-translated version of 粮油检验 谷物及其制品中钠、镁、钾、钙、铬、锰、铁、铜、锌、砷、硒、镉和铅的测定 电感耦合等离子体质谱法.
GB/T 35876-2018 is an inductively coupled plasma mass spectrometry method for measuring thirteen elements in cereals and cereal products: sodium, magnesium, potassium, calcium, chromium, manganese, iron, copper, zinc, arsenic, selenium, cadmium and lead.
The digested sample is nebulised into the plasma, the ions are separated by mass-to-charge ratio and the element contents are calculated against a standard series with internal standard quantification.
The standard lists the reagents, including nitric acid, hydrogen peroxide, a lithium, yttrium and thallium tuning solution, a scandium, germanium, indium and bismuth internal standard solution and mixed element standards, then the instruments, analysis steps, calculation of results and precision.
Food and grain testing laboratories use it. It was issued on 6 February 2018 and has applied since 1 September 2018.
Found what you need?
Document preview — GB/T 35876-2018
National Standard of the People's Republic of China
- ICS
- 67.060
- Classification
- X 11
Issued by: State Administration for Market Regulation; Standardization Administration of the PRC
Contents
- Foreword
- 1 Scope
- 2 Normative references
- 3 Principle
- 4 Reagents and materials
Foreword
This standard was drafted in accordance with the rules given in GB/T 1.1-2009.
1 Scope
This standard specifies the inductively coupled plasma mass spectrometry determination of cereals and their products sodium (Na), magnesium (Mg), potassium (K), calcium (Ca), chromium Principles of Reagents and Materials for Cr, Mn, Fe, Cu, Zn, As, Se, Cd and Pb,instrument Equipment and equipment, analysis steps, results calculation and precision requirements.
This standard applies to the determination of Na, Mg, K, Ca, Cr, Mn, Fe, Cu, Zn, As, Se, Cd and Pb in cereals and their products.
2 Normative references
The following documents for the application of this document is essential. For dated references, only the dated version applies to this document. For undated references, the latest edition (including all amendments) applies to this document.
GB/T 6682 analytical laboratory water specifications and test methods
3 Principle
The sample digestion solution is atomized and introduced into the plasma (ICP) by a carrier gas, passed through a high-temperature ion source by evaporation, dissociation, atomization, ionization, etc. Cheng, into positively charged ions, the ion reaches the mass spectrometer (MS) through the lens system, the mass spectrometer separates according to the mass-to-charge ratio, the mass spectrometry signal The intensity (CPS) is proportional to the number of ions entering the mass spectrometer, ie the ion count of the mass spectrum is positive with the concentration of the analyte in the sample solution Ratio, by measuring the number of ions in the mass spectrometry to determine the content of the sample elements compared with the standard series --- "internal standard method of quantification" to calculate the sample In the test element content.
4 Reagents and materials
Unless otherwise specified, the reagents used are excellent pure, the experimental water should be consistent with GB/T 6682 provisions of a water.
4.1 Nitric acid. phi (HNO3) = 65%, if necessary, re-distillation or use of high-purity reagents.
4.2 Hydrogen peroxide. phi (H2O2) = 30%.
4.3 Nitric acid solution (2 98). Measure 20 mL of nitric acid (4.1), slowly add 980 mL of water and mix well.
4.4 Mass spectrometry tuning solution. Buy a certified national standard solution directly; mixed mass spectrum tuning solution of lithium (Li), yttrium (Y), thallium (Tl), etc. The concentration is 10 µg/mL. Before use with nitric acid solution (4.3) diluted to a concentration of 0.010µg/mL.
4.5 Internal standard solution. directly purchase the certified national standard solution; scandium (Sc), germanium (Ge), indium (In), bismuth (Bi) Degree is 10 µg/mL. Before use with nitric acid solution (4.3) diluted to a concentration of 1.0µg/mL.
4.6 inorganic elements mixed standard stock solution. direct purchase of certified national standard solution; the concentration of sodium, magnesium, chromium, manganese, iron, copper, zinc, arsenic, Cadmium 50µg/mL, potassium, calcium, selenium, lead 100µg/mL.
4.7 Inorganic elements mixed standard solution. According to the need to learn appropriate amount of inorganic elements mixed standard stock solution (4.6), with nitric acid solution (4.3) The standard solution of sodium, magnesium, chromium, manganese, iron, copper, zinc, arsenic and cadmium was diluted to 5.0 µg/mL by level. Potassium, calcium, selenium and lead […]
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 15 pages — is available in the English PDF.
Referenced standards
Normative references
Similar standards
How to Download GB/T 35876-2018
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Fast delivery
After payment you'll receive an email confirmation. The English PDF is sent to the same address, usually within minutes and at the latest within 1 business day.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
GB/T 6682-1992 — Water for analytical laboratory use--Specification and test methods
GB/T 6682-2008 — Water for analytical laboratory use - Specification and test methods
GB/T 10003-2026 — Biaxially oriented polypropylene (BOPP) film
GB/T 35876-2018
$145.00