GB/T 33513-2017Belt drives -- Pulleys and V-ribbed belts for the automotive industry -- PK profile: Dimensions (English PDF)

Foreword

This Standard was drafted in accordance with the rules given in GB/T

1.1-2009.

This Standard uses redrafting method to modify and adopt ISO 9981.1998

Belt drives - Pulleys and V-ribbed belts for the automotive industry - PK profile.

Dimensions.

Compared with ISO 9981.1998, there are many modifications in this Standard

in structure. Annex A lists the contracts on sub-clause number between this

Standard and ISO 9981.1998.

There are technical differences between this Standard and ISO 9981.1998.

The sub-clauses covered by these differences have been identified by the

vertical single line (︱) at the margin of the outer margin. Annex B gives a list

of the corresponding technical differences and reasons.

This Standard also made the following editorial modification.

- deleted the descriptions of pulleys and V-ribbed belts used for industry

in the scope.

This Standard was proposed by China Petroleum and Chemical Industry

Federation.

This Standard shall be under the jurisdiction of Subcommittee on Friction

Type Belt Drive of National Technical Committee on Pulleys and Belts of

Standardization Administration of China (SAC/TC 428 / SC 3).

The drafting organizations of this Standard. Qingdao Institute of product

quality inspection technology, Ningbo Kai Chi Tape Co., Ltd., Hubei Maoxin

Special Tape Co., Ltd., Laiwu Yong Chi Rubber Co., Ltd., Zhejiang Zijin Port

Tape Co., Ltd., Henan Golden Jiulong Industrial Co., Ltd.

Main drafters of this Standard. Wu Guiqing, Hao Yongliang, Ying Jianli, Xiong

Lijun, Chen Yuezeng, Pang Changzhi, Zhang Liujie.

Belt drives - Pulleys and V-ribbed belts for the

automotive industry - PK profile. Dimensions

1 Scope

This Standard specifies the main dimensions of PK profile ring V-ribbed belts

and pulley grooves for automobile auxiliary transmission.

This Standard is applicable to ring V-ribbed belts and pulleys for PK profile

automobile auxiliary transmission.

2 Normative references

The following referenced documents are indispensable for the application of

this document. For dated references, only the edition cited applies. For

undated references, the latest edition of the referenced document (including

any amendments) applies.

GB/T 1184-1996, Geometrical tolerancing - Geometrical tolerance for

features without individual tolerance indications (egv ISO2768-2.1989)

GB/T 3505, Geometrical product specifications (GPS) - Surface texture.

Profile method - Terms definitions and surface texture parameters (GB/T

3505-2009, ISO4287.1997, IDT)

GB/T 11357, Quality roughness and balance of transmission pulleys (GB/T

11357-2008, ISO 254.1998, MOD)

GB/T 17516.2, V-and ribbed belts drive - Dynamic test to determine pitch

zone location - Part 2. V-ribbed belts (GB/T 17516.2-1998, idt ISO

8370-2.1993)

3 Pulley