GB/T 30559.2-2017Energy performance of lifts, escalators and moving walks -- Part 2: Energy calculation and classification for lifts (elevators) (English PDF)

Foreword

GB/T 30559 "energy performance of elevators, escalators and moving walkways" includes the following sections.

--- Part 1. Energy measurement and verification;

--- Part 2. Elevator energy calculation and classification;

--- Part 3. Energy calculation and classification of escalators and moving walkways.

This section GB/T 30559 Part 2.

This section drafted in accordance with GB/T 1.1-2009 given rules.

This section uses the translation method identical with ISO 25745-2.2015 "Elevators, escalators and moving walkways energy performance Part 2

Sub-elevator energy calculation and grading "(in English).

The documents of our country that are consistent with the corresponding international documents that are normative references in this section are as follows.

--- GB/T 30559.1-2014 energy performance of elevators, escalators and moving walkings - Part 1. Energy measurement and inspection

Card (ISO 25745-1.2012, IDT)

This section compared with ISO 25745-2.2015 made the following editorial changes.

--- Remove the introduction is not suitable for China's national conditions, as its existence or not does not affect the use of this section;

--- In the introduction, an increase of clause number, in order to facilitate reference;

--- In Chapter 4, an increase of the clause number for easy reference;

--- Adjust the order of Appendix A and Appendix C to comply with the provisions of GB/T 1.1-2009;

--- Modify Appendix C (Informative) Table C.1 "Typical buildings and use" and "typical rated speed" to suit our country

National conditions.

This part of the National Standardization Technical Committee elevator (SAC/TC196) and focal point.

This part of the drafting unit. KONE Elevator Co., Ltd., Shanghai Mitsubishi Elevator Co., Ltd., China Academy of Building Construction Mechanization Research

Research Branch, Shanghai Jiaotong University, Otis Electrical Elevator Co., Ltd., Schindler (China) Elevator Co., Ltd., Hitachi Elevator (China) Co., Ltd.

Division, Otis Elevator (China) Investment Co., Ltd., Conli Elevator Co., Ltd., Guangdong Special Equipment Inspection Institute, Shanghai Special Equipment

Supervision and Inspection Technology Research Institute, Yongda Elevator Equipment (China) Co., Ltd., Guangzhou Guangri Elevator Industry Co., Ltd., Southeast Elevator Co., Ltd.

Company, Shenzhen Special Equipment Safety Inspection Institute, Giant KONE Elevator Co., Ltd., Huasheng Fujitec Elevator Co., Ltd., Suzhou Dili Power

Ladder Co., Ltd., ThyssenKrupp Escalator (China) Co., Ltd., Mitsubishi Elevator Co., Ltd., Shenlong Elevator Co., Ltd.,

Ladder Group Co., Ltd., Shanghai Shida Electric Co., Ltd., the National Elevator Quality Supervision and Inspection Center, Danfoss automatic control management (on

Sea) Co., Ltd., Suzhou Monak Control Technology Co., Ltd., Guangzhou Ri-Bin Technology Development Co., Ltd., Hitachi Elevator (Guangzhou) escalators have

Limited, Shanghai Modern Elevator Manufacturing Co., Ltd.

Introduction

1 Scope

GB/T 30559 provisions of this section.

a) A method of estimating energy consumption based on measured data, calculations or simulations for a single hoisting, hydraulics and forcing

Estimated annual energy consumption of elevators;

b) Classification of energy performance of traction, hydraulic and forced-lift elevators based on a single new installation, in-service and retrofit.

This section applies to the rated speed greater than 0.15m/s passenger elevators and freight elevators, and only consider the use of the life cycle of the stage

The energy performance.

Note 1. For other types of elevators, such as debris elevators, this section can be used as a reference.

This section does not consider the following aspects that affect energy measurement, calculation, and simulation.

a) hoistway lighting;

b) car heating and cooling equipment;

c) machine space lighting;

d) heating, ventilating and air-conditioning installations in the machinery space;

e) non-elevator display systems and security CCTV cameras;

f) Non-elevator monitoring systems (eg, building management systems, etc.);

g) the impact of elevator group control allocation on energy consumption;

h) environmental conditions;

i) Energy consumption at the power outlet;

j) Elevator with fast-moving area.

Note 2. The fast-moving area does not necessarily affect the average car load but significantly affects the average operating distance.

2 Normative references

The following documents for the application of this document is essential. For dated references, only the dated version applies to this article

Pieces. For undated references, the latest edition (including all amendments) applies to this document.

ISO 25745-1 Energy performance of elevators, escalators and moving walkways - Part 1. Energy measurement and verification (Energyper-

formanceoflifts, escalatorsandmovingwalks-Part 1.Energymeasurementandverification)

3 Terms and definitions

ISO 25745-1 and defined by the following terms and definitions apply to this document.

Refer to Appendix A for the related symbols.

3.1

The average cycle averagecycle

The target elevator includes one cycle of ascending and one cycle of descending, and the mean distance traveled separately for each run. The cycle includes two complete

The switch door operation.