GB/T 30104.104-2025Digital addressable lighting interface - Part 104: General requirements - Wireless and alternative wired system components (English PDF)

Foreword

This document is in accordance with the provisions of GB/T 1.1-2020 "Guidelines for standardization work Part 1: Structure and drafting rules for standardization documents" Drafting.

This document is Part 104 of GB/T 30104 Digital Addressable Lighting Interface. GB/T 30104 has been published in the following parts.

--- Part 101: General requirements for system components;

--- Part 102: General requirements for control devices;

--- Part 103: General requirements for control equipment;

--- Part 104: General requirements for wireless and other wired system components;

--- Part.201.Particular requirements for control gear for fluorescent lamps (equipment type 0);

--- Part 202: Particular requirements for control devices Self-contained emergency lighting (equipment type 1);

--- Part 203: Particular requirements for control gear for discharge lamps (other than fluorescent lamps) (equipment type 2);

--- Part 204: Particular requirements for control gear for low-pressure tungsten halogen lamps (equipment type 3);

--- Part 205: Particular requirements for control gear for incandescent lamp supply voltage controllers (equipment type 4);

--- Part 206: Particular requirements for control devices converting digital signals into DC voltage (equipment type 5);

--- Part 207: Particular requirements for control gear LED modules (equipment type 6);

--- Part 208: Particular requirements for control devices switching functions (equipment type 7);

--- Part 209: Particular requirements for control devices Color control (equipment type 8);

--- Part 220: Particular requirements for control devices - Central power supply emergency operation (device type 19);

--- Part 222: Particular requirements for control devices heat lamp protection (device type 21);

--- Part 301: Special requirements for input device buttons;

--- Part 302: Special requirements for input devices, absolute input devices;

--- Part 303: Special requirements for input device occupancy sensors;

--- Part 304: Special requirements for input devices light sensors.

This document is equivalent to IEC 62386-104:2023 "Digital addressable lighting interface Part 104: General requirements for wireless and other Wired System Components.

The following minimal editorial changes have been made to this document.

--- Corrected the reference clauses (see 11.5.3, B.2.6, B.5.9);

Introduction

GB/T 30104 (all parts) specifies a bus system for controlling electronic lighting equipment through digital signals, which is intended to consist of the following Partial composition.

Part 103 specifies the general requirements for control devices. Part 104 specifies the general requirements for control equipment.

General requirements for wireless and alternative wired system components. Part 105 specifies general requirements for firmware upgrades. Part 150 the requirements for auxiliary power supplies are given. Auxiliary power supplies can be independent or built into the control device or control equipment.

Particular requirements for controlgear for certain types of luminaires.

Special requirements for each type of input device.

GB/T 30104 is published as a series of standards divided into several parts to facilitate future revision and amendment, and to add new parts when necessary.

Other requirements.

The structure and relationship of the series of standards are shown in Figure 1 as follows.

Figure 1 Overview of GB/T 30104

Other sections also include additional requirements.

Unless otherwise specified, all numbers used in this document are decimal. Hexadecimal numbers are given in the format 0xVV.

The "x" in the number means "any value".

Use the following typographical expressions.

Variable. "variable name" or "variable name[3.0]" only gives the 3rd to 0th digits of the variable name.

The range of values is. [minimum, maximum].

Command. "command name".

Digital Addressable Lighting Interface Part 104: General requirements for wireless and other wired System components

1 Scope

This document specifies the electrical specifications of the telecommunication system, telecommunication unit power supply, transmission protocol framework structure, timing, operation method, Variable declaration and instruction definition.

This document applies to systems with wireless or other wired communication capabilities between units.

"Wireless or other wired communication" is referred to as "telecommunication" and is a communication system that is different from the bus system described in IEC 62386-101.

network.

NOTE. The definition of "telecommunication" applies only to this document and is different from 701-01-05 in IEC 60050-701:1988.

2 Normative references

The contents of the following documents constitute the essential clauses of this document through normative references in this document.

For referenced documents without a date, only the version corresponding to that date applies to this document; for referenced documents without a date, the latest version (including all amendments) applies to this document.

IEC 62386-101:2014 Digital addressable lighting interface Part 101: General requirements System components (Digital IEC 62386-101:2014/AMD1.2018 Note. GB/T 30104.101-2025 Digital addressable lighting interface Part 101: General requirements system components (IEC 62386-101:2022, IDT) IEC 62386-102:2014 Digital addressable lighting interface Part 102: General requirements for control gear IEC 62386-102:2014/AMD1.2018 Note. GB/T 30104.102-2025 Digital addressable lighting interface Part 102: General requirements system components (IEC 62386-102:2022, IDT) IEC 62386-103:2014/AMD1.2018 Digital addressable lighting interface Part 103: General requirements Control gear Note. GB/T 30104.103-2017 Digital Addressable Lighting Interface Part 103: General Requirements Control Equipment (IEC 62386-103:2014, IDT) (all sections)]