GB/T 22792.3-2008Office furniture -- Screens -- Part 3: Test methods (English PDF)

Foreword

GB 22792 "Office furniture screen" is divided into three parts.

--- GB/T 22792.1 "Office furniture - Screens - Part 1. Dimensions";

--- GB 22792.2 "Office furniture - Screens - Part 2. Safety requirements";

--- GB/T 22792.3 "Office furniture - Screens - Part 3. Test methods." this section is part of 3 GB 22792.

The partial modification of the use of EN1023-3:2000 "Office furniture - Screens - Part 3. Test methods." this portion of EN1023-3. Compared to 2000, the main changes are as follows.

--- Modify the scope of the provisions of the Stability and test methods for structural changes for the office screen provides office screen ruler Inch, safety requirements and test methods for general structural safety requirements;

--- Measured increase screen size;

--- Increase measurement screen general safety requirements;

--- Delete international standards informative overview of elements (including the cover, directory, foreword and introduction);

--- Increase in Appendices A and B.

Appendix A of this section is normative appendix, Appendix B is an informative annex.

This part is proposed by the China National Light Industry Council.

This part of the furniture by the National Standardization Center centralized.

This part of the main drafting unit. Shanghai Quality Supervision, Inspection Technology Research Institute, Beijing Furniture Industry Association, Zhejiang Fangyuan Detection Group shares Parts Limited, Shenzhen Academy of Metrology and Quality Inspection, wood furniture, Beijing Quality Supervision, Inspection Station, Beijing Liming Wen-Furniture Co.

the company.

Participated in the drafting of this section. Zhejiang Sunon Furniture Manufacturing Co., Huayuan Xuan Furniture (Shenzhen) Co., Ltd., Shenzhen Hammer Industries Development Co., Ltd., Guangdong Oriental Furniture Co., Ltd., Shanghai Aurora Furniture Co., Ltd., Guangzhou Paliburg Industrial Co., Ltd., Zhuhai Lai Induced Matheson office furniture Limited, Beijing this holy Mei Furniture Manufacturing Co., Ltd., Ningbo Steel Co., Ltd of emerging intelligent, Beijing Century Beijing Thai Furniture Co., Ltd. Gifted than (China) Co., Ltd., Beijing O SigmaTel Furniture Co., Ltd. Hebei Jeroen furniture.

1 Scope

This section GB 22792 specifies the screen size of the office, the general safety requirements and test methods for structural safety requirements.

This section applies to the office wall.

2 Normative references

The following documents contain provisions which, through reference in this Part of GB 22792, constitute provisions of this part. Cited documents dated, its all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encourage each agreement under this section are Prescriptions can use the latest versions of these documents. For undated reference documents, the latest versions apply to this section.

GB/T 2828.1-2003 Sampling procedures for inspection - Part 1. by acceptance quality limit (AQL) retrieval batch test sample plan GB 22792.2-2008 Office furniture - Screens - Part 2. Safety requirements (EN1023-2:2000, IDT)

3 Terms and Definitions

The following terms and definitions apply to this part of GB 22792.

Various furniture components connected to the screen (tables, shelves, wall cabinets, sliding lateral file drawers, etc.).

4 General test conditions

The manufacturer shall indicate the recommended installation method in the user manual wall structure, components, and how to use the screen with different accessory connection Wind, as well as the maximum load for each type of screen (kilograms per meter on the screen width of the loaded).

If the screen is not designed for this test procedure should be possible to carry out the test according to the description, and indicate any deviations in the test report. when Screen design does not satisfy the test procedure, the test report should be as described and claimed any deviation from the implementation of these tests.