GB/T 18910.2-2003Liquid crystal and solid-state display devices -- Part 2: Liquid crystal display modules sectional specification (English PDF)

Foreword

The expected structure of GB/T 18910 "Liquid crystal and solid-state display

devices" is as follows.

Part 1.Generic specification;

Part 2.Liquid crystal display modules sectional specification;

Part 2-1.Passive matrix monochrome LCD modules - Blank detail

specification;

Part 3.Sectional specification for liquid crystal display (LCD) cells;

Part 3-1.Liquid crystal display (LCD) - Blank detail specification;

Part 4.Liquid crystal display modules and cells - Essential ratings and

characteristics;

Part 5.Environmental endurance and mechanical test methods;

This is part 2 of GB/T 18910, which equivalently adopts IEC 61747-2.1998 (QC

720300) "Liquid crystal and solid-state display devices - Part 2.Liquid crystal

display modules sectional specification" (English version).

To facilitate use, this part has made the following editorial changes.

a) USE the decimal point "." to replace the comma "," which is used as the

decimal point;

b) DELETE the foreword to the international standard;

c) In clause 2, ADD the referenced international standard "IEC 61747-5";

d) In clause 4.6, according to the actual contents of GB/T 18910.1 (IEC

61747-1.1998, IDT), CHANGE "3.6" into "5.6";

e) In note 1 to Table 5, according to the actual contents of GB/T 18910.1 (IEC

61747-1.1998, IDT), CHANGE "2.6" to "4.5".

This part was proposed by the Ministry of Information Industry of PRC.

This part shall be under the jurisdiction of the China Electronics Standardization

Institute (CESI).

Drafting organization of this part. China Electronics Standardization Institute

(CESI).

Liquid crystal and solid-state display devices - Part 2.

Liquid crystal display modules sectional specification

1 Scope

This sectional specification applies to liquid crystal and solid-state display

modules such as the following.

- Static / segment type liquid crystal display modules;

- Passive matrix monochrome liquid crystal display modules;

- Passive matrix color liquid crystal display modules;

- Active matrix monochrome liquid crystal display modules;

- Active matrix color liquid crystal display modules.

It gives details of the Quality Assessment Procedures, the inspection

requirements, screening sequences, sampling requirements, and test and

measurement procedures required for the assessment of liquid crystal display

modules.

Note 1.Instead of the Qualification Approval Procedure, the Capability Approval

Procedure (see Rules of Procedures QC 001002, subclause 11.7), which is at

present under consideration, may be used for all products manufactured in a

defined process.

Note 2.All the requirements of this specification remain valid, unless modified

by the requirements set out by the new clause. Capability Approval Procedure

(under consideration).

2 Normative reference

The following normative document contains provisions which, through

reference in this text, constitute provisions of this part of GB/T 18910.For the

dated references, the subsequent amendments (excluding corrections) or

revisions do not apply to this standard; however, parties who reach an

agreement based on this standard are encouraged to study if the latest versions

of these documents are applicable. For undated references, the latest edition

of the referenced document applies.

......