GB 4706.106-2011Household and similar electrical appliances -- Safety -- Particular requirements for outdoor barbecues (English PDF)

Foreword

All technical contents of this section is mandatory.

GB 4706 "and similar household electrical appliances," it consists of several components, Part 1 General Requirements for the other parts of special

Claim.

This section is part of the 106 GB 4706.

This section should GB 4706.1-2005. with "safe 1 Household and similar electrical appliances General requirements."

This section drafted in accordance with the rules GB/T 1.1-2009 given.

This section uses the translation method identical with IEC 60335-2-78.2008 "Household and similar electrical appliances - Safety - part 2-78. households

Special requirements "outside grill.

This section made the following editorial changes.

--- In this section of Chapter 1 Note 102 2nd column items, remove the IEC 60335-2-78.2008 Note 1 of Chapter 102 of 2

Column items "in many countries."

1 Scope

The chapter GB 4706.1-2005 is replaced by the following.

This section provides a single phase safety appliance does not exceed the rated voltage of 250V household and similar outdoor grill.

Not for normal household use, but the public may still cause dangerous instruments, such as going to the shops, light industry and farms by non-professionals

Member of the apparatus used within the scope of this standard.

101 Note. Examples of such instruments are. the use of such equipment in hotels and restaurants.

Common hazards presented by the appliances covered in this section, is in and around the home environments of all people may experience.

However, in general, this section does not cover.

--- people (including children) due

- body, perception or mental ability, or

- lack of experience and knowledge,

It can not be used safely in danger when the appliance without supervision or instruction;

--- children playing instruments situation.

102 Note. Note the following conditions.

--- intended for use in the ship's instruments, it may require some additional requirements;

--- additional requirements are specified by national health authorities, the national protection of labor and similar sectors.

This does not apply to.

--- grill used indoors (GB 4706.14);

--- plan to use charcoal or similar combustible fuel burning appliances;

--- specifically intended as equipment for industrial purposes;

--- appliances used in special circumstances, for example, corrosive or explosive atmosphere (dust, steam or gas).

2 Normative references

The following documents for the application of this document is essential. For dated references, only applies to the version dated paper

Pieces. For undated references, the latest edition (including any amendments) applies to this document.

The chapter GB 4706.1-2005 applicable except as follows.

increase.

GB/T 2423.18 electric and electronic products environmental testing - Part 2. Test Method Test Kb. Salt mist, cyclic (sodium chloride

Solution) (GB/T 2423.18-2000, IEC 60068-2-52.1996, IDT)

3 Terms and Definitions

The following terms and definitions apply to this document.

The chapter GB 4706.1-2005 applicable except as follows.

4 General requirements

The chapter GB 4706.1-2005 is applicable.

General conditions for 5 tests

The chapter GB 4706.1-2005 applicable except as follows.

101 Note. If the appliance needs to be tested 15.101, increase the three samples.

Category 6

The chapter GB 4706.1-2005 applicable except as follows.

7 Marking and instructions

The chapter GB 4706.1-2005 applicable except as follows.

8 Protection against access to live parts

The chapter GB 4706.1-2005 is applicable.

9 start electric appliances

GB 4706.1-2005 This chapter does not apply.

Power input and current 10

The chapter GB 4706.1-2005 is applicable.

11 fever

The chapter GB 4706.1-2005 applicable except as follows.

12 Void

Leakage current and electric strength at the operating temperature of 13

The chapter GB 4706.1-2005 is applicable.

14 transient overvoltage

The chapter GB 4706.1-2005 is applicable.

15 Moisture resistance

The chapter GB 4706.1-2005 applicable except as follows.

15.101 intends to partially or fully immersed in water to clean the appliance should have sufficient anti-flooding capability.

On 3 additional samples, the following tests to determine their eligibility.

Under normal operating conditions of the appliance to 1.15 times the rated power of the power supply until the thermostat first working operation. Appliances without a thermostat

Work to establish a stable state apparatus. Disconnect the power and unplug all appliances connector. Then, the appliance is completely immersed in from about 1%

NaCl, temperature (10 ~ 25) aqueous solution of °C, if the appliance is marked with the maximum scale line immersion tool will scale line immersion beyond 50mm

Deep position.

After IH, the equipment is removed from the aqueous solution of the salt, is subjected to drying appliance leakage current test of 16.2.

Note. Be careful to make sure that the water on the appliance inlet pin all around the insulation removed.

To implement the above test four times again, after each test instrument should be subjected to electric strength test of 16.3, the test voltage specified by Table 4.

After the fifth water immersion test, the appliance open sensed current value and the maximum leakage inspection, the inspection should not able to show in the insulating

Enough to cause creepage distance and clearance is reduced to traces of liquid in Chapter 29 below a predetermined limit.

The remaining two samples under normal operating conditions to 1.15 times the rated power-supply work 240h. After completion of the test from the electrical appliance

1h disconnected and immersed in water again. After drying 16.3 subjected to electric strength test, the test voltage specified in Table 4.

It showed no check should lead to clearance and creepage distances to reduce traces of liquid 29 is below a predetermined chapter on the appliance insulation.

16 Leakage current and electric strength

The chapter GB 4706.1-2005 is applicable.

Overload protection of transformers and associated circuitry 17

The chapter GB 4706.1-2005 is applicable.

18 Endurance

GB 4706.1-2005 This chapter does not apply.

19 Abnormal operation

The chapter GB 4706.1-2005 applicable except as follows.

20 Stability and mechanical hazards

The chapter GB 4706.1-2005 is applicable.

21 Mechanical strength

The chapter GB 4706.1-2005 applicable except as follows.

22 Construction

The chapter GB 4706.1-2005 applicable except as follows.

25 and the external power connection cord

The chapter GB 4706.1-2005 applicable except as follows.

27 earthing

The chapter GB 4706.1-2005 is applicable.

28 and screw connection

The chapter GB 4706.1-2005 is applicable.

Clearances 29, creepage distances and solid insulation

The chapter GB 4706.1-2005 applicable except as follows.

30 Resistance to heat and fire

The chapter GB 4706.1-2005 applicable except as follows.

31 rust

The chapter GB 4706.1-2005 applicable except as follows.

increase.

Appliance by GB/T 2423.18 severity of grade 2 Test Kb. salt spray test to check their eligibility.

Before the test, scoring the coating with a hardened needle. Needle end portion has a conical apex angle of 40 °, a radius of a rounded tip

(0.25 ± 0.02) mm. Applying an appropriate load to the needle, so as to exert a force in the axial direction of (10 ± 0.5) N. Along the surface of the coating

Rate of about 20mm/s drag needle, scoring five scratches, scratches distance of at least 5mm, and from the edge of at least 5mm.

After the test, the appliance should not be damaged to influence the degree of compliance with this part, especially chapters 8 and 27. Coating should not be cracked or

Loose from the metal surface.

32 radiation, toxicity and similar hazards

The chapter GB 4706.1-2005 is applicable.

appendix

Appendix GB 4706.1-2005 is applicable.

references

Reference GB 4706.1-2005 applicable except as follows.

increase.

[1] GB 4706.14 special requirements for grills, toasters and similar portable cooking appliances (IEC 60335-2-9, IDT)

[2] ISO 13732-1 Ergonomicsofthethermalenvironment-Methodsfortheassessmentofhu-

manresponsestocontactwithsurfaces-Part 1. Hotsurfaces

END: Draft Version (GB 4706.106-2011)