GB 29928-2013Food additive -- Acid-treated starch (English PDF)

2.1 Raw materials

2.1.1 Raw materials

Food starch should be consistent with national standards or industry standards-related products.

2.1.2 Accessories

2.1.2.1 should meet the national standards or industry standards or the relevant provisions of the relevant requirements of the product.

2.1.2.2 acid treatment reagent type. hydrochloric acid, phosphoric acid or sulfuric acid.

2.2 Sensory requirements

Sensory requirements shall comply with the requirements of Table 1.

Table 1 Sensory requirements

Project requires test methods Color white, white or light yellow Take 50 g sample in a clean white porcelain dish, under natural light, observation its color, state, smell the smell Status granular, flaked or without visible impurities Inherent odor product smell, no odor

2.3 Physical indicators

Physical and chemical indicators should be consistent with the provisions of Table 2.

Table 2. Physical and chemical indicators

Item Index Test Method Loss on drying, w /% Cereal starch <= 15.0 GB/T 12087 other monomers starch <= 18.0 Potato starch <= 21.0 Total arsenic (As)/(mg/kg) <= 0.5 GB/T 5009.11 Lead (Pb)/(mg/kg) <= 1.0 GB 5009.12 Sulfur dioxide/(mg/kg) <= 30 GB/T 22427.13 Appendix A Testing method A.1 Safety Tips Reagents The standard test methods used for toxic or corrosive, be careful when operating! As should be immediately splashed on the skin Rinsed with water, severe cases should be treated immediately.

A.2 General Provisions Unless otherwise indicated in the analysis using only recognized as analytical reagents and GB/T 6682 stipulated three water. Test Methods the standard titration solution, impurity measurement standard solution, preparations and products, did not indicate when the other requirements, according to GB/T 601, GB/T 602 and 603 of the regulations prepared GB/T ; the solution when the solvent is not specified, refer to the aqueous solution.

A.3 Identification Test A.3.1 microscopy Without pasting process to maintain acid-treated starch granule structure, can be directly observed and verified starch particle shape, size and character through a microscope.

Under polarized light microscope, it can be observed the typical birefringence.

A.3.2 iodine staining 1 g of the sample was added 20 mL of water were suspended, several drops of iodine solution, the color should range from deep blue to reddish brown.

A.3.3 copper reduction A.3.3.1 formulated alkaline tartrate copper test solution A.3.3.1.1 Solution A. Copper Sulfate (CuSO4 · 5H2O) 34.66 g, should be no weathering or moisture absorption phenomenon, dissolved in water volume to 500 mL.

The solution was stored in a small sealed container.

A.3.3.1.2 Solution B. take potassium sodium tartrate (KNaC4H4O6 · 4H2O) 173 g sodium hydroxide 50 g, dissolved in water volume to 500 mL.

The solution was stored in a small container and alkali corrosion.

A.3.3.1.3 solutions A and B mixed in equal volumes, to obtain an alkaline tartrate copper test solution.

A.3.3.2 analysis step Weigh the sample 2.5 g, placed in a flask, 0.82 mol/L hydrochloric acid solution of 10 mL of water and 70 mL, mixing, boiling water bath back Stream 3 h, cooled. Take 0.5 mL solution was cooled, added 5 mL hot alkaline copper tartrate solution, a large amount of red precipitate.