GB 28645.2-2012Safety code for inspection of dangerous goods -- Non-spillage electric storage (English PDF)

Foreword

This standard Chapter 4, Section 5, Chapter 7 and Chapter 8 is mandatory, the rest are recommended.

This standard was drafted in accordance with rules GB/T 1.1-2009 given.

This standard and the United Nations "on the Recommendations on the Transport of Dangerous Goods Model Regulations" (sixteenth revised edition) the degree of non-conformity

Equivalent.

This standard is proposed and managed by the Dangerous Chemicals Management Standardization Technical Committee (SAC/TC251).

This standard was drafted. Hunan Entry-Exit Inspection and Quarantine Bureau Technology Center, Tianjin Entry-Exit Inspection and Quarantine Bureau, Jiangnan University.

1 Scope

This standard specifies the wet sealed battery terms and definitions, requirements, performance test, packaging and inspection predetermined rules.

This standard applies to the risk of wet sealing performance test battery.

2 Normative references

The following documents for the application of this document is essential. For dated references, only applies to the version dated paper

Pieces. For undated references, the latest edition (including any amendments) applies to this document.

GB/T 2828.1 Sampling procedures - Part 1. According to accept the quality limit (AQL) retrieve the batch inspection sampling plan

GB 19458 safety inspection of hazardous properties of dangerous goods - General specifications

UN "Recommendations on Transport of Dangerous Goods Model Regulations of" (sixteenth revised edition)

3 Terms and Definitions

GB/T 2828.1 Definition The following terms and definitions apply to this document.

3.1

Inspection lot inspectionlot

The same brand of material, the same production process of continuous production, the battery of the same size and dimensions, referred to as batch.

4 Requirements

5 Performance Test

6 Sampling

Sampling general appearance by GB/T 2828.1 normally detected for single sampling II general inspection level, the number of samples in Table 1 Performance Test,

3 is the number of samples.

Table 1 Appearance of sampling Number of Units member

Bulk sampling number range

1 ~ 82

9 ~ 153

16 to 255

26 to 508

51 to 9013

Table 1 (continued) Unit of member

Bulk sampling number range

91 to 15020

151 to 28,032

281 to 50050

501 to 120,080

1201 ~ 3200125

3201 to 5.0002 million

7 packing provisions

7.1 packaging container should comply with the transport of dangerous goods regulations, the use of the outer container should be suitable material of adequate strength and capacity according to

The capacity to adapt and use the design and manufacture of packaging container category equal to or higher than the packing group required for the transport of dangerous goods.

Be cast or printed marks and batch printing and packaging, packaging indicia on 7.2 packaging container, lot number should be correct, clear, strong, consistent GB 19458 have

Customs requirements.

7.3 packaging container surfaces should be clean, does not allow cause dangerous residues, contamination, without leakage.

7.4 packaging should be firmly secured in the outer packaging, to prevent cracking occurs during normal transport, puncture or leak. The battery should be protected

Preventing a short circuit occurs in the container.

7.5 between the outer container and the container should be sufficient cushioning material to prevent leakage of a battery liquid.

7.6 will not start to ring with the dangerous goods loaded chemical reaction and lose sealing effect or impact quality of the goods.

7.7 pressure test and vibration test was not leaked battery if the battery is part of a mechanical or electronic device and is actuated

Apparatus necessary, be firmly secured to the battery holder and the apparatus be protected from damage and short circuit.

8 Inspection Rules

2 to 501

8 ~ 1312