FZ/T 90060.8-2005Textile machinery. Product drawing and design document. Part 8: Examination of standardization (English PDF)

Foreword

FZ/T 90060 includes the following nine parts under the general title of "Textile Machinery Product Drawings and Design Documents".

--- Part 1. General;

--- Part 2. Numbering;

--- Part 3. Requirements for drawings;

--- Part 4. Requirements for design documents;

--- Part 5. Format;

--- Part 6. Integrity;

--- Part 7. Change;

--- Part 8. Standardization review;

--- Part 9. Management.

This part is part 8 of the FZ/T 90060.

This part is based on the needs of enterprises to implement computer-aided design (CAD) and enterprise management assurance system and product market competition.

According to the relevant national standards and industry standards, fully consider the characteristics of the textile machinery industry, refer to JB/T 5054.7-2000 "mechanical product map Revised on the basis of the Standardization Review of Samples and Design Documents.

This section is a new addition.

Appendix A of this section is an informative annex.

This part was proposed by the China Textile Industry Association.

This part is under the jurisdiction of the National Textile Machinery and Accessories Standardization Technical Committee.

This section is mainly drafted by. China Textile Machinery Research Institute, Zhengzhou Textile Machinery Co., Ltd., Shaoyang Textile Machinery Co., Ltd., Jingwei Textile Machinery Co., Ltd., China Textile Machinery (Group) Co., Ltd., Best Machinery Manufacturing Co., Ltd.

1 Scope

This part of FZ/T 90060 specifies the content and requirements for the standardization review of textile machinery product drawings and design documents.

This section applies to the standardization review of product drawings and design documents in the textile machinery industry. Standards for other product drawings and technical documents the review can also refer to implementation.

2 Normative references

The provisions in the following documents become the provisions of this part by reference to this part of FZ/T 90060. Quotations with dated , all subsequent amendments (not including errata content) or revisions do not apply to this section, however, encouragement is achieved under this section the parties to the agreement study whether the latest versions of these documents can be used. For undated references, the latest edition applies to this section.

GB/T 14665 Mechanical Engineering CAD Drawing Rules GB/T 17825 (all parts) CAD file management FZ/T 90060.1 Textile machinery product drawings and design documents - Part 1. General FZ/T 90060.3 Textile machinery product drawings and design documents - Part 3 FZ/T 90060.4 Textile machinery product drawings and design documents - Part 4. Requirements for design documents FZ/T 90060.5 Textile machinery product drawings and design documents - Part 5. Format

3 Terms and definitions

The terms and definitions established by FZ/T 90060.1 apply to this part of FZ/T 90060.

4 Basic requirements

4.1 The basis for standardization review is related to technical regulations and standards at all levels. After standardization review, it should be achieved.

a) The designed product complies with relevant national technical regulations;

b) The designed products meet the requirements of national standards, industry standards and enterprise standards;

c) Prioritize the use of stereotyped design and structural solutions, and maximize the use of standard parts, general parts, borrowed parts to improve design Inheritance and standardization of products;

d) rational selection of basic standards and raw material standards such as priority numbers and structural elements of parts;

e) Product drawings and design documents comply with relevant standards and are correct, complete, clear and uniform.

4.2 Outsourcing or self-developed CAD software should be standardized for review, check whether it meets national standards and other according to GB/T 17825 Standard regulations.

4.3 Standardization review is based on the premise that design and proofreaders consciously implement various standards, in product development decision, preliminary design, and technology.

All stages of design and construction design are carried out.

5 Scope and content of the standardization review