DZ/T 0276.31-2015Regulation for testing the physical and mechanical properties of rock. Part 31: Test for determining the sound velocity of rock of rock mass (English PDF)
岩石物理力学性质试验规程 第31部分:岩体声波速度测试 清晰版
This is a limited preview
Buy now to download the full PDF (6 pages)
Need quotation for your management?
Get a formal quotation for DZ/T 0276.31-2015 in 30 minutes.
Issued by
Ministry of Land and Resources
Level / Type
National · Recommended
Issue date
February 4, 2015
Implementation date
April 1, 2015
Scope
DZ/T 0276.31-2015 is the English-translated version of 岩石物理力学性质试验规程 第31部分:岩体声波速度测试 清晰版.
DZ/T 0276.31-2015 — This part of DZ/T 0276 specifies the test method for determining the acoustic velocity of rock mass. This section applies to the measurement of rock mass acoustic velocity in rock physical and mechanical properties test.
Found what you need?
Document preview — DZ/T 0276.31-2015
National Standard of the People's Republic of China
- ICS
- 19.020
- Classification
- D 00
Issued by: Ministry of Land and Resources
Contents
- Foreword
- 1 Scope
- 2 Normative references
- 3 Principle
- 4 Basic requirements
- 4.1 Measuring point arrangement
Foreword
DZ/T 0276 "Testing Procedures for Physical and Mechanical Properties of Rocks" is divided into 31 parts.
--- Part 1. General and general provisions;
--- Part 2. Rock moisture test;
--- Part 3. Rock particle density test;
--- Part 4. Rock density test;
---Part 5. Rock water absorption test;
---Part 6. Rock hardness test;
--- Part 7. Rock gloss test;
--- Part 8. Rock antifreeze test;
---Part 9. Rock resistance to disintegration test;
--- Part 10. Rock expansion test;
--- Part 11. Rock erosion test;
--- Part 12. Rock acid and alkali resistance test;
--- Part 13. Rock specific heat test;
--- Part 14. Rock thermal conductivity test;
---Part 15. Rock breakdown voltage and breakdown strength test;
---Part 16. Rock volume resistivity and surface resistivity test;
--- Part 17. Rock radioactivity specific activity test;
---Part 18. Rock uniaxial compressive strength test;
---Part 19. Rock uniaxial compression deformation test;
--- Part 20. Rock triaxial compression strength test;
--- Part 21. Rock tensile strength test;
--- Part 22. Rock flexural strength test;
--- Part 23. Rock point load strength test;
--- Part 24. Rock acoustic wave velocity test;
---Part 25. Rock shear strength test;
--- Part 26. Rock mass deformation test (bearing plate method);
--- Part 27. Rock mass deformation test (drilling deformation method);
---Part 28. Rock mass strength test (direct shear test);
--- Part 29. Rock mass strength test (bearing plate method);
--- Part 30. Rock bolt load test;
--- Part 31. Rock sound wave velocity test.
This part is part 31 of DZ/T 0276.
This part is drafted in accordance with the rules given in GB/T 1.1-2009.
This part is proposed by the Ministry of Land and Resources of the People's Republic of China.
This part is under the jurisdiction of the National Land Resources Standardization Technical Committee (SAC/TC93).
1 Scope
This part of DZ/T 0276 specifies the test method for determining the acoustic velocity of rock mass.
This section applies to the measurement of rock mass acoustic velocity in rock physical and mechanical properties test.
2 Normative references
The following documents are indispensable for the application of this document. For dated references, only the dated version applies to this article.
Pieces. For undated references, the latest edition (including all amendments) applies to this document.
DZ/T 0276.24 Test procedures for physical and mechanical properties of rocks - Part 24. Rock acoustic wave velocity test
3 Principle
By obtaining the propagation time and spectral characteristics of the elastic wave, combined with the geological features of the measured rock mass, the lithology, mass and weathering process of the rock mass the degree and the degree of development of the fracture are quantitatively determined.
4 Basic requirements
4.1 Measuring point arrangement
4.1.1 The measuring points may be selected from representative engineering rock mass parts in flat boring, drilling, wind drilling or surface outcrops.
4.1.2 The line for isotropic rock mass should be arranged in a straight line; for the anisotropic rock mass, the parallel and vertical rock mass should be respectively Structural plane layout.
4.1.3 The distance between two adjacent measuring points, when using transducer excitation, the distance should be 1m~3m; when using electric spark excitation, the distance should be 10m~30m; when using hammering excitation, the distance is not less than 3m.
4.1.4 In the single hole test, the distance between the transmitting point and the receiving point shall not be less than 0.5m, and the moving distance of the transducer shall not be less than 0.1m.
4.1.5 The two bore axes for the penetration test between the holes are parallel to each other, and the transmitting and receiving transducers should be in the same plane. Any depth in the hole the distance should be equal to the distance between the center points of the two orifices.
4.1.6 When performing the hole penetration test in drilling or wind drilling, the transducer should be moved from 0.1m to 1.0m each time.
......
This preview omits tables, figures, formulas and parts of the technical clauses. The complete document — 6 pages — is available in the English PDF.
How to Download DZ/T 0276.31-2015
- 1
Add to cart
Click "Download PDF" on this page and choose "Buy this standard". You can add more standards before checkout.
- 2
Checkout
Enter your email and billing details. Payment is processed securely by Stripe (cards or bank transfer). Prefer bank details? Request a quotation (min. order $300).
- 3
Instant delivery (0–9 sec)
Delivery is automatic: within seconds of payment you'll receive an email with a secure download link. The link stays valid for 72 hours.
- 4
Invoice included
A tax invoice is attached to the confirmation email. Need a custom invoice? Contact us.
Related Standards
DZ/T 0276.1-2015 — Regulation for testing the physical and mechanical properties of rock. Part 1: General rules and regulations
DZ/T 0276.10-2015 — Regulation for testing the physical and mechanical properties of rock. Part 10: Test for determining the swelling property of rock
DZ/T 0276.11-2015 — Regulation for testing the physical and mechanical properties of rock. Part 11: Test for determining the dissolution of rock
Secure payment via Stripe
Payments accepted
DZ/T 0276.31-2015
$90.00